&Tradition Flowerpot VP3 Verner Panton 1968 User manual

Congratulations on your new Flowerpot table lamp,
designed in 1968 by Verner Panton. We hope you will
enjoy using this product and follow these instructions
to ensure correct use. If you have any questions or
comments, please do not hesitate to contact us by
mail on:
in[email protected]
Flowerpot VP3
Verner Panton
1968
Instructions

A
Flowerpot VP3
Verner Panton
1968
B
C
D
E
01/21
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
ALamp shade
B Lamp base
C Logo ring & ball nut
D Shade stand
E Lamp holder ring
Tools needed
- Bulb type E27
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children’s reach.
- The lamp is only intended for interior use.
- Lamp exterior gets hot after prolong use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere with a risk of falling over it.
- If the external cable or cord of this lamp is damaged,
it must be replaced by the manufacture or a similar
qualified person in order to avoid a hazard.
Cleaning instructions
- Wipe surface of the glass shade with a soft, damp sponge
or cloth, and wipe immediately with a dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or sti brushes.
- Never use strong cleaning agents such as white spirit,
turpentine, household glass cleaner or cellulose thinners.
- Only wipe the inside of the shade with a soft, damp cloth
or feather duster.
Step 1
Unpack the lamp. Place the shade stand onto the socket
and fix in place by mounting the plastic ring.
Step 2
Place the light bulb on the socket and ensure that it sits
tight. Avoid using a bulb which comes in direct contact
with the shade.
Step 3
Place the shade on top of the shade stand. Put the logo
ring on top of the shade and mount and tighten the ball
nut. Ensure that the shade is tightly assembled to
the lamp.
For indoor use only
E27 maximum 40W
Bulb not included

Step 4
Connect the lamp to an electrical socket and enjoy
using your new lamp.
andtradition.com