&Tradition Journey SHY1 User manual

Congratulations with your new Journey lamp, designed
in 2018 by Signe Hytte. We hope you will enjoy using
this product and follow these instructions to ensure
correct installation. If you have any questions or
comments, please do not hesitate to contact us by mail
on:
in[email protected]
Journey SHY1
Signe Hytte
2018
Instructions

A
Journey SHY1
Signe Hytte
2018
B
12 cm
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Contents
ALamp
B Transformer with interchangeable plugs
Tools needed
This lamp can be used both as a table lamp and as a wall
lamp. If you choose to install it as a wall lamp the following
tools are needed.
- Screws and plugs (for the specific wall type)
- Electric drill
- Screwdriver
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children’s reach.
- The lamp is only intended for interior use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere there is a risk of falling over it.
Cleaning instructions
- Wipe surface of lamp with a soft, damp sponge or cloth,
and wipe immediately after with a dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or sti brushes.
- Never use strong cleaning agents such as white spirit,
terpentine, household glass cleaner or cellulose thinners.
- Mirror color: Cleaning of stainless steel should be done
only by using a cleaning detergent specifically for stainless
steel. Follow the instructions on the packaging. Cleaning
agents not developed specifically for stainless steel may
permanently damage the surface of the stainless steel
and should never be used. For daily care, please only use
a dry soft cloth to clean.
Step 1
In order to use the lamp as a wall lamp, two screws or hooks
are needed. Choose where the lamp shall be placed on the
wall and mark it with a pencil. With a ruler and a spirit level,
measure a 12 cm distance in a vertical line and mark where
the second screw or hook is to be placed.
Step 2
Drill holes on the marks and insert the correct type of
screws and plugs, appropriate for the wall of installation.
Step 3
The lamp is now ready to be installed by placing the holes in
the lamp base over the screws.
Step 4
Adjust the light intensity to desired level by turning the
dimmer on the side
For indoor use only
Built-in LED (non replaceable)
220-240V
Installation on wall
03/21

andtradition.com