Antop AT-414B Service manual

AT-414B
UFO
SMARTPASS
AMPLIFIED HDTV ANTENNA
OUTDOOR/ RV / ATTIC

House Use
INSTRUCTIONS
Installation Instruction Manual
ANTOP’s New Generation Digital Technology
Your UFO Smartpass Amplified HDTV Antenna / AT-414B can be used either as an outdoor, RV
or attic antenna. ANTOP’s New Generation Digital Technology allows you the flexibility to set up
your antenna in various locations and still receive a great digital reception.
Following are instructions for installation options for outdoor use as a mast pole mount or wall
mount, as well as for indoor options in an attic or on an RV. Read through all instructions prior
to beginning installation procedure.
Note: A higher mounting location positioned towards the broadcast tower may result in
better reception. Install the antenna as high as possible, and preferably with a clear path
between the antenna and the TV station transmitters. Trees, buildings, mountains, etc.,
can all impact the performance of any antenna. This antenna can also be placed in an
attic.
• Smartpass Amplifier: all-in-one design allows easier connection, delivers correct balance
between short and long range reception.
• 4G LTE Filter: blocks 3G and 4G wireless signals to ensure noise-free digital TV reception.
• Omni-directional Reception with enhanced VHF Range.
1
RV Use

1 / Installation
Install a mast pole (not provided) on the house or RV, preferably on rooftop or the side of the
house/RV facing the TV station transmitters. Attach the antenna to the mast pole by using the
clamp kit provided.
Attach the bracket to the antenna unit using the screw and wing nut provided.
Take off the clamp kit from the antenna. Determine the location on the wall where the antenna
is to be mounted, preferably on the side of the house/RV facing the TV station transmitters. Fix
the antenna onto the wall with screws (screws not provided).
1.1 For Outdoor Use of House or RV, Mast Pole Mounting
1.2 For Outdoor Use of House or RV, Wall Mounting
2
TV Station
Transmitters

2 /Connecting
2.1.1 Select entry point to house. Drill hole under the eaves at entry point. Attach coaxial
cable with water proof cap end to connector in the antenna. For horizontal Wall Mount utilize
U-shape coaxial cable setup to prevent water from entering interior of antenna casing. With
antenna fixed to either a mast pole or an exterior wall, feed lose end of coaxial cable through
drilled opening.
Select entry point to house. Drill hole at entry point. Attach coaxial cable with water proof cap
end to connector in the antenna. Fix the antenna onto beam or wall. Feed lose end of coaxial
cable through drilled opening.
2.1 For Outdoor Use, Mast Pole or Wall Mount Prepping for Connection
2.2 For Indoor Use, in Attic placement, Prepping for Connection
Connect other end of the coaxial cable to the short coaxial cable from power inserter. Attach
the long coaxial cable from power inserter to the ANTENNA/CABLE IN connector on the back of
the TV or converter box. Connect the power adapter to the DC socket in power inserter. The
antenna must be powered in order to function.
2.3 If you haven’t already done so, attach coaxial cable to connector in
the antenna
3
Determine location in attic where antenna will be placed. To mount antenna onto a beam or
wall, preferably on the side of the house facing the TV station transmitters, fix the antenna
onto the beam or wall with screws (screws not provided).
1.3 For Indoor Use, In Attic
The bottom of antenna

4
The Power Inserter must be powered in order to function.
Push the smart switch On or Off and select the switching
with which more channels are received.
·Switch Off - The LED indicates yellow for normal reception.
·Switch On - The LED indicates green for stronger reception.
OFF/ONLED
Scan channels after each switching in the power inserter.
!
Back of TV
CABLE IN
ON/OFF LED
ANT/IN2
3 /Setting and Scanning
In the TV’s setup menu, set the mode to “Antenna” or “Air”, then, set TV to “Scan” for channels.
Consult the TV manual for detailed instructions.
CHANNEL SCAN
scanning for channels
3

5
4 /Adjusting Instruction
For the best omni-directional reception, a clear path between transmitter and antenna is
needed. It is better to keep the dome in a horizontal position. In the case that there are
obstacles surrounding the house, the signal will be reflected and weakened. Please release
screw “A” and adjust the dome up and down for the best reception angle, then fasten the
wing nut.
Screw A

Warranty Policy
Manufacturer, Antop Antenna Inc., warranties its products for a period of one
year from the date of original purchase. The warranty is valid only with original
proof of purchase of the product. This warranty does not apply to any defects or
failures of product caused by neglect, misuse, negligence, accident, abuse,
mishandling, misapplication, alteration, modification, power outage, unautho-
rized/unreasonable use, or any uncontrollable environmental damage.
Exchange Replacement Service Agreement
Standard 1 year limited Manufactory warranty on Replacements of a product
for exchange due to malfunction, failure or defected, part(s), missing components
exchanges will be for the same item, model, Sku, within the 1 year purchased date.
No upgrades or exchanges for a different Model/Sku please send us an email
at [email protected] or contact our representatives for troubleshooting
for RMA number email [email protected] to receive a replacement or refund.
When shipping an item back, you should consider using a traceable shipping
service such at tracking number or purchasing shipping insurance especially for
higher ticketed items.Exchanged products must be sent to: 2313 E Philadelphia
St. STE L Ontario CA 91761 and must contain an RMA number and copy of proof
of purchase.
Return Refund Policy
Note: Standard 30-day money back and/or refunds to USA only. Returned merchandise
must have RMA number on box and one copy of proof of purchased inside package.
RMA number will be obtained in advance from Antop Antenna customer service
representative returns department. A stocking fee of 15% can be deducted from
a refund ask representative for further details.
Absolutely no refund after 30 days of purchase. For any return
for refund, customers should contact their place of purchase
to find out the retailer’s return policy.