Antop OMNIPRO Series User manual

LAVA Electronics Inc.
Tech Support: 909-235-6611 www.lavasat.com
E-mail:[e-mail]
RVHD-2000
OMNIPRO series
AM:520-1719KHz FM:47-230MHz
UHF:470-862MHz
Gain:30dBPower
Supply: DC 12V==50mA
Step 1: Choosing a Location: Make sure the mounng locaon has a
sufficient flat area so the antenna’s mounng stand can be mounted flat.
Step 2: Drilling holes: Use the mounng bracket as a template to determine
where to drill the holes.
Step 3: Assembling the Antenna: Rotate the antenna’s locking nut all the
way down on the base. Gently pull the antenna’s cables thru the mounng
stand. Screw the antenna onto the mounng stand then rotate up the locking
nut to lock the antenna into place.
Step 4: Attaching the Antenna: Feed the cables thru the hole on the roof.
Put the mounng bolts thru the holes in the mounng stand. On the interior,
place the mounng bracket then use the nuts to secure the antenna.
Step 5: Wiring: Connect the cables from the antenna to distribuon wall
plate and to the radio. Connect the power cables from the distribuon wall
plate according to the diagram below.

LAVA Electronics Inc.
Tech Support: 909-235-6611 www.lavasat.com
E-mail:[e-mail]
OMNIPRO series
RVHD-2000