Anytrek ThermoTrack VT2002 User manual

Installation
Guide
Solar Powered 4G Connected Tanker
Thermometer with GPS Tracking
ThermoTrack
VT2002

Copyright © 2021 by Anytrek Corporation All Rights Reserved. No part of this document
may be reproduced, copied, translated, or incorporated in any other material in any form
or by any means, whether manual, graphic, electronic, mechanical, or otherwise, without
the prior written consent of Anytrek Corporation.
You are welcome to use the products of Anytrek Corporation. (Hereinafter referred to as Any-
trek). This document is intended to help you understand and use the product. For accuracy and
reliability, Anytrek may make improvements and/or changes to this document at any time and
without notice. If you experience any problems in use or have any suggestions, please contact
us via the contact info provided in this document. We will do our best to resolve any issues, as
well as evaluate and implement any suggestions.
Trademark
The Anytrek logo and ThermoTrack brand are trademarks of Anytrek Corporation.
Statement Disclaimer

Part I：Remove Existing Equipment
Remove thermometer

Part II：Install ThermoTrack
（Suitable for 3-inch mounting hole）
Step 1. Fix sensor
Fix the sensor with the fixing clip
Sensor Sensor Fixing clip

Part II：Install ThermoTrack
（Suitable for 3-inch mounting hole）
Step 2. Insert insulation foam
Step 3. Install Pad
Insulation foam Thickness not
less than 2 inches
1.Run the sensor connector through the hole.
2.Keep no space gap to ensure insulation.
Pad Flange holder Pad Flange holder

Keep “TOP” pointing up
Step 6. Fix the main unit.
Fix the main unit with four screws provided.
Keep “TOP” pointing up

[phone] [email protected]om
USA Offices
West Coast: 4405 E. Airport Dr., Suite 106, Ontario, CA 91761
East Coast: 1554 B, Hwy. 80 East, Pooler, GA 31322
[phone] [email protected]
Canada Office
11535 1st Avenue, Suite 309, Saint-Georges, Québec, G5Y 7X3
[phone] [email protected]
Mexico Office
Salamanca Juventino Rossas KM 0.5 C, Salamanca GTO, CP 36750