Anzzi ENVO TL-AZEB101B User manual
ITEM: TL-AZEB101B
TL-AZEB103B
TL-AZEB105B
ANZZI ELECTRIC BIDET SEAT
INSTALL & OPERATION MANUAL
V1.0
EN
byANZZI
PRODU REGITION*
T O
DOTTED E
PRODUCT SIZE CHART
ENVO Electric Bidet Seat.
SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
SAFETY PRECAUTIONS
DANGER
WARNING
PG.1
NOTE
==
Wrench Screwdriver
PG.4
I
►
covered
PG.6
•
Electric Bidet seat
Water supply valve
Select a smooth and even surface to ensure the control holder remains seated.
Tear off the adhesive tape and press against wall.
NOTE: Clean the surface prior to affixing the control holder. Apply pressure firmly
and evenly. Allow 15 minutes for adhesive to cure.
Open water supply valve and check for any leaks.
Make sure the plug is plugged into the socket and the light is on. Press the “Test”
button: The plug light should be off. Press the “RESET” button: The light of the plug
should be on.
DO NOT USE IF “TEST & RESET” FAILS!
CALL TECHNICAL SUPPORT FOR MORE ASSISTANCE.
When the Electric Bidet Seat is powered ON, you will hear an audible beep.
When the cover is lifted a small amount of water will flow to pre-wet the inner
bowl.
After the user sits on the seat a small amount of water will flow to wash the
nozzle.
This key will stop any currently running function. Press and hold
for 3 seconds (when not sat on) to turn OFF the power. Press and
hold for 3 seconds again to turn the power back ON. Press and
hold for 3 seconds (while sitting) to start the dryer function. The
air temperature can be preset by the Air Temp key on the remote
control.
While sitting, press this key to start the rear wash. The runtime is
4 minutes. Press the key again to turn ON/OFF the reciprocating
cleaning. The water temperature can be preset by the Water Temp
key of the remote control.
While sitting, press this key to start the front wash. The runtime is
4 minutes. Press the key again to turn ON/OFF the reciprocating
cleaning. The water temperature can be preset by the Water Temp
key of the remote control.
Press this key to stop any function currently active.
Press and hold for 5 seconds (while NOT sitting) to turn
power ON/OFF.
While sitting, press this key to start the Front Wash.
The runtime is 4 minutes.
When Front Wash is active:
Press this key again to turn reciprocating cleaning ON/OFF.
Press the “Massage” key to turn Massage ON/OFF.
Press the “Position /\ V” key to adjust the stream’s position.
Press the “Water Temp” key to adjust the water temperature.
Press the “Water Pressure +/-” key to adjust the water pressure.
While sitting, press this key to start the Rear Wash.
The runtime is 4 minutes.
When Rear Wash is active:
Press this key again to turn reciprocating cleaning ON/OFF.
Press the “Massage” key to turn Massage ON/OFF.
Press the “Position /\ V” key to adjust the stream’s position.
Press the “Water Temp” key to adjust the water temperature.
Press the “Water Pressure +/-” key to adjust the water pressure.
While sitting, press this key to start the “Dryer” function.
The runtime is 4 minutes.
When the dryer function is ON press the “Air Temp” key to
adjust the air temperature.
While sitting, press and hold for 2 seconds to start the
“Child Wash” function. The runtime is 4 minutes.
Low-level water pressure and temperature is locked to ensure
a safe washing experience for the child.
Press this key during rinsing to select between 3 levels of water
pressure. Except for Child Wash.
Press this key during rinsing to select between 3 stream positions.
NOTE: When the reciprocating cleaning or drying function is ON,
the nozzle position cannot be adjusted. This function is only
applicable to Rear, Bidet, Hot/Cold Spa modes.
This function can only be activated when rinsing is ON (except for
Hot/Cold Spa and Child Wash). When activated the water stream’s
pressure will alternate to achieve the massaging effect. Press the
key to turn this function ON/OFF.
While sitting, press this key to start the “Hot / Cold Spa” function.
The runtime is 4 minutes.
The water temperature will alternate between hot and cold.
While rinsing pressing this key will turn ON/OFF the reciprocating
cleaning mode.
Press the “Water Temp” key to adjust the water temperature.
Press the “Water Pressure +/-” key to adjust the water pressure.
Press this key to turn Energy Saving mode on. The indicator light
on the side panel will turn ON. When ON, the Energy Saving mode
will automatically turn OFF when the user sits on the seat. It will
automatically turn ON 10 minutes after the user leaves the seat.
Press and hold for 3 seconds to turn ON/OFF the Night Light. The
light will remain on for 10 minutes then automatically turn OFF.
Press this key to cycle between 4 different seat heating temperatures.
Normal / Low / Medium/ High.
The more lights on, the higher the temperature.
Press this key to cycle between 4 different water temperatures.
Normal / Low / Medium/ High.
The more lights on, the higher the temperature.
Press and hold for 3 seconds to turn ON/OFF the inner bowl
pre-wetting function.
Press and hold the UP arrow key for 3 seconds when NOT seated.
The nozzle will extend out and self-wash with water. While the
nozzle is out you can use a brush to clean the nozzle. Press the
“Stop” key to retract the nozzle.
Press this key to cycle between 4 different air dryer temperatures.
Normal / Low / Medium/ High.
The more lights on, the higher the temperature.
Press and hold for 3 seconds to turn ON/OFF the deodorizer.
CLEANING&MAINTENANCE
Product surface maintenance
Nozzle cleaning and maintenance
(AI
�
Clean the filter screen
RNING
AENTION
PG.14
LONG-TIME PERSERVATION
\
�
�I
PRODUCT PARAMETERS
/
°C ± °()
°C ± °C)
°C ± °()
FUNCTION LIST
Photocatalyst
B
-
O
C)
j
b
H
W
CJ
)
)
/� "\
\J
(�)
_) 1 '\
H
F
/
F
W
W
,J
Note: "O" represents the configuration of this function.
The function is based on the actual machine.
PG,Hi
This manual suits for next models
2
Table of contents
Other Anzzi Bathroom Fixture manuals
Anzzi
Anzzi CS-FRKD00 Series User manual
Anzzi
Anzzi PRAIRE & Mayor SP-AZ8092 User manual
Anzzi
Anzzi SP-AZ8097 User manual
Anzzi
Anzzi TUNDRA SP-AZ039 User manual
Anzzi
Anzzi Visor SP-AZ035 User manual
Anzzi
Anzzi CS-FRGLPNL00 Series User manual
Anzzi
Anzzi BYNE Series User manual
Anzzi
Anzzi SD-FRLS05901 Series User manual
Anzzi
Anzzi Rhaus SP-AZ029 User manual
Anzzi
Anzzi SP-AZ028 User manual
Anzzi
Anzzi Sifo KF-AZ301 Series User manual
Anzzi
Anzzi Key L-AZ097 User manual
Anzzi
Anzzi SD-AZ056-01 Series User manual
Anzzi
Anzzi SD-AZ054-01 Series User manual
Anzzi
Anzzi LLANO SP-AZ044 User manual
Anzzi
Anzzi Leopard SP-AZ032 User manual
Anzzi
Anzzi TRYNN SP-AZ025 User manual
Anzzi
Anzzi LLANO SP-AZ045 User manual
Anzzi
Anzzi CS-FRKDGL00 Series User manual
Anzzi
Anzzi LANN SP-AZ015 User manual
Popular Bathroom Fixture manuals by other brands
Jacuzzi
Jacuzzi SPRAY GUARD installation instructions
antoniolupi
antoniolupi INTRECCIO installation manual
HappyOrNot
HappyOrNot Smiley Wall Assembly guide
Devon & Devon
Devon & Devon Savoy K Assembly instructions
WimTec
WimTec OCEAN P10 Assembly and operating instructions
Hans Grohe
Hans Grohe AXOR Citterio 39620000 Instructions for use/assembly instructions
Gessi
Gessi RETTANGOLO 26609 Bath Mixing Program
Kebo
Kebo SH-PN-7142 manual
Peerless Faucet
Peerless Faucet Core PTT188743 quick start guide
DUSCHY
DUSCHY 523n-70 installation manual
Fantini Rubinetti
Fantini Rubinetti Venezia 3429000001 Care and maintenance
Hans Grohe
Hans Grohe Rainfinity 130 3jet 26864700 Assembly instructions