APS 79165 User manual
APS Battery
Charger
Manual
Specifications
APS
SKU 79165
Input voltage, V 5
Output voltage, V 4.2
Mains voltage range, V 100-240
Compatible with batteries APS2/APS3
Charge temperature range (RH
60±25%) 0 … 45 °С
Dimensions, mm 71x32x31
Weight, kg 0.05
Description
APS Battery Charger is designed to charge Battery Packs APS2 and APS3
used with digital and thermal riflescopes, thermal monoculars by Pulsar.
Package Contents
APS Battery Charger
Mains charger
USB Cable
User manual
Warranty card
Safety Measures
Only use this APS Battery Charger or the charger from the package
contents of your device to charge APS2/APS3 batteries. The use of any
other charger may irreparably damage the Battery Pack or the charger
and may cause fire.
During long-term storage, the Battery Pack should be partially charged –
the charge level should be between 50% and 80%.
Do not charge the battery immediately after bringing the battery from
cold environment to a warm one. Wait for 30-40 minutes for the battery
to get warm.
Do not leave a battery unattended while charging.
Do not leave the Battery Pack with a charger connected to the mains
longer than 24 hours after full charge.
Do not expose the battery pack to high temperature or to a naked flame.
Do not submerge the battery in water.
The Battery Pack is short circuit protected. However, any situation that
may cause short-circuiting should be avoided.
Do not dismantle or deform the Battery Pack and Battery Charger.
Do not drop or hit the Battery Pack and Battery Charger.
When using the battery at negative temperatures, battery's capacity
decreases, this is normal and is not a defect.
Keep the battery out of the reach of children
Battery Charging
1. Install the rechargeable battery (not included) (1) along the guides
until stop into the charger's (4) slot.
2. Point А on the battery and point B on the charger should match.
3. You can charge two batteries at the same time – a second slot is
designed for this purpose.
4. Connect the plug of the USB cable (7) to the port (5) of the charger (4).
5. Connect the second plug of the USB cable (7) to the USB port on the
mains charger (3).
6. Plug the mains charger (3)into a socket 100-240V(6).
7. LED indicator (2) will show battery charge status (see the table).
(2) LED Indicator* Battery charge status
Battery charge from 0 to 10%.
Charger not connected to the
mains power supply
Battery charge from 0 to 10%.
Charger connected to the
mains power supply
Image not found or type unknown Battery charge from 10 to 20%
Battery charge from 20 to 60%
Image not found or type unknownImage not found or type unknown Battery charge from 60 to 95%
Image not found or type unknownImage not found or type unknownImage not found or type unknown
Battery completely charged.
Charging will automatically
stop. The battery can be
disconnected from the charger.
Battery defective. Do not use
the battery!
* Indication shows the current battery charge level for 30 seconds if the APS
charger is not connected to the mains. Once connected to the mains,
indication shows current battery charge level permanently. LED indicators
also glow showing charging process.
Legal Compliances and
Disclaimers
The manufacturer reserves the right at any time, without mandatory notice,
to make changes to the package contents, design and characteristics that
do not impair the quality of the product.
Table of contents
