Aquasana AQ-SFRO-S1S3 User manual

Protect your investment and save money
with our Water for Life program.
Free
Shipping
Discounted
Replacements
No
Contract
[email protected]
CONTACT US TO LEARN MORE 866-662-6885
Aquasana, Inc.
4343 S. Hamilton Road
Groveport, OH 43125
866-662-6885 USA
877-332-7873 Canada
www.aquasana.com 100368703
Certied by WQA to NSF/ANSI Standard
42, 53, 401, and CSA B483.1 when used
in the AQ-SFRO for the reduction of the
claims specied on the Performance
Data Sheet and at www.WQA.org.
For the full list of
contaminants ltered,
scan to view the
Performance Data Sheet
on Aquasana.com.
AQ-SFRO-S1S3
Under Sink Water Filter
Owner’s Manual
SmartFlow™Reverse Osmosis Carbon Block
and Advanced Carbon Block Replacements
REPLACEMENT
The recommended replacement frequency for the AQ-SFRO-S1S3 is every 6 months or 365 gallons of use.
Use only certied, genuine Aquasana replacement lters for continued contaminant removal and
system performance.
Extended
Warranty
For use with AQ-SFRO

Turn o COLD water valve. Release pressure from system by turning on
dedicated faucet until water stops owing. Once water stops owing from
the dedicated faucet, turn the faucet o.
Unbox lter cartridge replacements and remove plastic.
Remove the Carbon Block lter cartridge from Stage 1 by turning the
handle to the left and pulling out. Discard entire lter cartridge. Repeat for
the Advanced Carbon Block (Stage 3).
1
2
3
4
5
6
7
8
NOTE: Do not drink ushed water.
Scan to view the SmartFlow™ Reverse
Osmosis lter replacement video.
INSTALLATION STEPS
Prepare for Installation
Insert each lter cartridge into its designated location in the system
manifold by turning to the right with the handle vertically aligned. The guides
on each lter will ensure proper alignment within the system manifold.
Once the lter is engaged, push the lter fully in while rotating 90 degrees
to the right. Continue this step for each lter.
•Top Filter: Carbon Block
• Bottom Filter: Advanced Carbon Block
Insert Filter Cartridges
Flush and Check for Leaks
Turn on COLD water valve and conrm
dedicated faucet is o. While tank rells,
carefully inspect for leaks.
After the water tank is full, turn on
the dedicated faucet and empty the
tank again.
Once the water tank is empty, turn o
the dedicated faucet and allow tank to rell.
Repeat this step two more times. Once you
have emptied three tanks of water, close all
faucets and rell for regular use.
NOTE: It will take 1-3 hours for the water tank
to rell.
STAGE 1
Carbon Block
STAGE 2
SmartFlow
™
Membrane
STAGE 3
Advanced Carbon Block
Care
To clean the system manifold and tank, wipe exterior with a damp cloth.
Do not use any strong or abrasive cleaning agent or solvent cleaner.
NOTICE – Safeguards: If you are experiencing a tubing connection leak,
shut o COLD water, disconnect and re-set the tube.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Conforms to NSF/ANSI 53 for VOC reduction. See performance data sheet
for individual contaminants and reduction performance.
Systems certied for cyst reduction may be used on disinfected waters
that may contain lterable cysts.