Aquolab AQBAS01 User manual
AQUOLAB®BASIC (AQBAS01)
User’s manual
The dental water jet Aquolab mixes water and ozone directly produced inside the
Tannerella Forsythia (TF)
Fusobacterium Nucleatum (FN)
Porphyromonas Gingivalis (PG)
Campylobacter Rectus (CR)
EN
IMPORTANT
damaged parts
GENERAL RULES FOR A CORRECT ORAL HYGENE
water jet
TECHNICAL SPECIFICATIONS
20121 Milano
Model Aquolab Basic
Voltage supply
Class II
Applied part Handle (type B)
Dimension 190 mm x 140 mm x h150 mm
Usage temperature +5°C ÷ +40°C
EN
EXPLANATION OF LABELLING SYMBOLS
Symbol Meaning
Type B applied part
handles)
DIRECTIONS FOR ELECTROMAGNETIC COMPATIBILITY
EN
Emission test Compliance Electromagnec environmental - guidance
RF Emission
CISPR 11 Group 1
RF Emission
CISPR 11 Class B
Harmonic emissions
Class A
Compliant
e model “AQUOLAB BASIC” is intended for use in the electromagnetic environment specied below.
e customer or the user of the “AQUOLAB BASIC” should assure that is used in such an environment.
Immunity test IEC 60601-1-2
Test level Compliance Level Electromagnetic environmental - guidance
Electrostatic discharge (ESD)
IEC 61000-4-2
+/- 6kV contact
+/- 8kV air
+/- 6kV contact
+/- 8kV air
Floors should be wood, concrete or ceramic tile. If
oor are covered with synthetic material, the relative
humidity should be at least 30%.
Electric fast transient / burst
IEC 61000-4-4
+/- 2kV
for power supply
+/- 2kV
for power supply
Mains power quality should be that of a typical
commercial or hospital environment.
Surge
IEC 61000-4-5
+/- 1kV
dierential mode
+/- 1kV
dierential mode
Mains power quality should be that of a typical
commercial or hospital environment.
Voltage dips, short interruptions
and voltage variation on power
supply input lines
IEC 61000-4-11
<5% Ut
(> 95% dip in Ut) for
0.5 cycle
40% of Ut
(60% dip in Ut) for
5 cycle
70% of Ut
(30% dip in Ut) for
25 cycle
<5% Ut
(> 95% dip in Ut)
for 5 s
<5% Ut
(> 95% dip in Ut) for
0.5 cycle
40% of Ut
(60% dip in Ut) for
5 cycle
70% of Ut
(30% dip in Ut) for
25 cycle
<5% Ut
(> 95% dip in Ut)
for 5 s
Mains power quality should be that of a typical com-
mercial or hospital environment. If the user of the
“AQUOLAB BASIC” requires continued operation
during power main interruption, it is recommended
that the
“AQUOLAB BASIC” be powered from an uninter-
ruptible power supply or a battery.
Power frequency
(50/60 Hz)
magnetic eld
IEC 61000-4-8
3 A/m 3 A/m -
EN
Table of contents
Other Aquolab Medical Equipment manuals
Popular Medical Equipment manuals by other brands
Getinge
Getinge Arjohuntleigh Nimbus 3 Professional Instructions for use
Mettler Electronics
Mettler Electronics Sonicator 730 Maintenance manual
Pressalit Care
Pressalit Care R1100 Mounting instruction
Denas MS
Denas MS DENAS-T operating manual
bort medical
bort medical ActiveColor quick guide
AccuVein
AccuVein AV400 user manual
