Aristel AN1804 User manual

INSTALLATION
This 4G Intercom is suitable for both flush and surface mounting.
Note:
For surface mounting, you will have to remove the plastic enclosure before fitting main
station into the stainless steel cabinet.
AN1804 4G
QUICK INSTALL GUIDE
1/3

Intercom Unit
Speaker
Call Button
Microphone
Wiring Diagram
AN1804 4G QUICK INSTALL GUIDE
2/3

LED INDICATORS
1. LED “Intercom Status “ Indicator
LED Status
Yellow (standby) Flashes once per 5 seconds
Yellow (using) Solid
2. LED ‘Network “Indicator
LED Status
Green (ready) Flashes once per 3 seconds
Green (searching) Flashes once per second
Green (busy) Solid
3.LED “ Power “ Indicator
LED Status
Red (power on) Solid
Red (power off) Off
1. SIM card
Register your SIM card with the network, and check it works in a mobile phone
You MUST remove the PIN request from the SIM before inserting it in the unit.
Ensure the power is OFF before inserting the SIM card. Carefully slide the SIM holder in the
OPEN direction, insert the SIM, and slide in the CLOSED direction to lock it in place.
2. Antenna
Install the antenna as high as possible for best possible reception.
3. Door Lock
Connect an electric door lock to terminals marked “door latch”.
4. Power Supply
Connect a 12-24 volt power source to terminals marked “AC, AC”
The power supply should be capable of supplying a constant current of no less than 1amp.
5. After a final check of wiring , switch on the power
6. Allow 20~30 seconds for the unit to boot up and detect the network. Once a successful
connection has been made, the unit will sound a confirmation tone and the status LED will
begin flashing.
AN1804 4G QUICK INSTALL GUIDE
3/3