Aristel AN1808-12M User manual

Installation
This 4G audio intercom is suitable for both flush mounting and surface mounting.
4G AUDIO INTERCOM
(SURFACE MOUNTING)
4G AUDIO
INTERCOM
(FLUSH MOUNTING)
AN1808-12M (MULTI)
QUICK INSTALLATION GUIDE
Keypad
Speaker
Microphone
Call button
1/4

1. SIM card installation (Fig 1)
1.1 Disconnect the power from the intercom.
1.2 Remove the rear plastic cover
1.3 Remove the SIM card cover from the bottom of the unit
1.4 Slide the SIM card holder towards the front of the unit
1.5 Lift up the holder
1.6 Before inserting the SIM card, ensure that it is not PIN number
locked. (If
locked, use a mobile phone to unlock it).
1.7 Insert the SIM card (Note orientation of notched corner)
1.8 Replace holder and slide towards the rear of the unit to lock in place
1.9 Replace rear plastic cover
AN1808-12M (MULTI) QUICK INSTALL GUIDE
2/4

2. Connecting with the door lock system (Fig 2)
2.1 According your door lock type, see wiring diagrams below.
3. Connecting the Antenna (Fig 3)
3.1 Plug in the antenna cord to the connector on the rear of the unit
3.2 Place antenna away from electrical/electronic systems (computers,
microwave ovens, etc
3/4

4. Power on.
4.1 Connect the 12-24v power source to the connector marked AC
4.2 The blue indicator of call button should be on and you will hear Du
Du tone. 4.3 Position the intercom where it will be installed.
4.4 When the Du Du tone has ceased, the device is ready.
Wiring Diagram
AN1808-12M (MULTI) QUICK INSTALL GUIDE
4/4