Aristel AN1808-12S User manual

Installation
This 4G audio intercom is suitable for both flush mounting and surface mounting.
4G AUDIO INTERCOM
(SURFACE MOUNTING)
4G AUDIO
INTERCOM
(FLUSH MOUNTING)
AN1808-12S (SINGLE)
QUICK INSTALLATION GUIDE
Keypad
Speaker
Microphone
Call button
1/4

1. SIM card installation (Fig 1)
1.1 Disconnect the 12V adaptor from the intercom.
1.2 Remove the rear plastic cover
1.3 Remove the SIM card cover from the bottom of the unit
1.4 Slide the SIM card holder towards the front of the unit
1.5 Lift up the holder
1.6 Before inserting the SIM card, ensure that it is not PIN number
locked. (If
locked, use a mobile phone to unlock it).
1.7 Insert the SIM card (Note orientation of notched corner)
1.8 Replace holder and slide towards the rear of the unit to lock in place
1.9 Replace rear plastic cover
AN1808-12S (SINGLE) QUICK INSTALL GUIDE
2/4

2. Connecting with the door lock system (Fig 2)
2.1 See below for your relevant door lock type wiring instructions.
3. Connecting the Antenna (Fig 3)
3.1 Plug in the antenna cord to the connector on the rear of the unit
3.2 Place the antenna away from electrical/electronic systems (computers,
microwave ovens, etc.
AN1808-12S (SINGLE) QUICK INSTALL GUIDE
3/4

4. Power on.
4.1 Connect the power adaptor into the connector marked AC
4.2 The blue indicator of call button should be on and you will hear Du
Du tone. 4.3 Fix the unit in position before activating.
4.4 When the Du Du tone has disappeared, the device is ready.
Wiring Diagram
AN1808-12S (SINGLE) QUICK INSTALL GUIDE
4/4