After you have wired all the receivers according to Figure illustration you need to do the following:
1. Pull off the plastic lm cover of the battery at the back of remote.
2. Pair remote with receiver: short press the Learning Key on the receiver, then immediately short
slide touch
Once you do that, the LED lights will ash. The remote and receiver are paired!
3. Do the same step 2. to pair endless quantity of receivers to the remote, to control in sync.
4. CCT & mono dim shift: hold button for 5 seconds to shift the CCT and mono dim mode,
then slide touch
to do the control.
In case you want to reset the re-
ceiver: when receiver is powered,
long press Learning Key for 10
secs. Re assigning the receiver to a
different remote is easy, just repeat
Step 2. as above.
1. The product shall be installed and serviced by a qualied person.
2. IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a
water proof enclosure.
3. Always be sure to mount this unit in an area with proper ventilation to avoid overheating.
4. Please check if the output voltage of any LED power supplies used comply with the working volt-
age of the product.
5. Never connect any cables while power is on and always assure correct connections to avoid short
circuits before switching on.
6. Please ensure that the cable is secured tightly in the connector
7. For update information please consult your supplier.
