Asko T700 Series User manual

Laundry
Washers
Dryers
Under Counter Installations
These units can be installed in free-standing installa-
tions. This shows the traditional built-in layout: dryer
on left and washer on right. To reverse this, simply
reverse the installation specs. These units can also be
built in under a 34 to 35 high counter. The
minimum counter width is 49 for a pair. This 49
width allows 1/2 of space on the outside edges and
between the units, otherwise units may bump
wall/cabinet or each other during spin cycles. This
also allows for sufficient air circulation for dryer.
Electrical, Water And Code Requirements
The washers have a 220 V line that plugs into an ASKO dryer or a standard 220 V, 20 amp single phase outlet. ASKO
dryers plug into standard 220V, 30 amp circuit. The washers connect to the cold-water outlet. The water pressure must be
between 15 – 146 PSI. Second floor (above grade) installations must meet all local building codes.
See Use &Care Guide for detailed installation instructions.
23-7/16
33-1/2
to 34-1/2
23-7/16 or 24-7/16
23-7/16
33-1/2
to 34-1/2
23-7/16 or 24-7/16
23-7/16 or 24-7/16
67 to 69
23-7/16
Depth with Door Open
W600 & W640 — 36-3/8
W620 & W660 — 42-3/8
Depth with Door Closed
W600 & W620 — 24-7/16
W640 & W660 — 23-7/16
Depth with Door Open
46-1/16
Depth with Door Closed
T700 & T720 — 24-7/16
T760 & T780 — 23-7/16
5-1/2
23-3/4 or 24-3/4
49 Minimum
34
to 35
15-3/4
Minimum
Hot &
Cold Water
4-23/32 4-1/8
Drain
Hole Diameter
5-1/2
5-1/2
220V,
30 Amp
Outlet
18
INSTALLATION