Asus AAEON BOXER-8233AI Operation manual

Most Confidential
Confidential
Internal
Public
V
NVIDIA Jetson TX2 NX Platform
NVIDIA Jetpack 4.5
BOXER-8233AI
May 2021
Revision 1.0
Installation User Guide

1
Revision History
Revision
Date
Description
1.0
May 2021
Initial release.

2
Contents
Revision History..............................................................................................................1
1. Preparing................................................................................................................3
1.1. Pre-requisites.............................................................................................3
1.2. In Linux Host...............................................................................................4
2. To Flash Image........................................................................................................5
2.1. Flash Image to Board .................................................................................5

3
1.Preparing
1.1. Pre-requisites
1. Prepare an image compressed file. Its name will be like
ACLinux_4.9_{OS_IF}.{PLF_IF}.{PJ_IF}.{BN}.tar.gz
I. {OS_IF} is OS Information; e.g. NJ450Xwhich NJ means Nvidia Jetpack, 450
means Nvidia Jetpack 4.5 and X means Desktop version.
II. {PLF_IF} is Platform Information; e.g.NV06
III. {PJ_IF} is Project Information; e.g. BOXER-8233AI
IV. {BN}is Build Number; e.g. 0,1,2,...,N
2. Prepare one host PC that OS is Ubuntu 18.04
3. Prepare Jetson TX2 NX module.

4
1.2. In Linux Host
1. Unzip image compression file on Ubuntu Host PC.
$tar -zxvf ACLinux_4.9_{OS_IF}.{PLF_IF}.{PJ_IF}.{BN}.tar.gz
2. Connect the BOXER-8233AI to power supply.
3. Press and hold down the recovery key and then press the power key.
After 2 seconds, release the recovery key. The target board should
enter recovery mode
4. Connect Host PC and BOXER-8233AI via micro USB.
5. If device is in recovery mode, lsusb command on host PC will list a
line of “0955:7c18 NVidia Corp”

5
2.To Flash Image
2.1. Flash Image to Board
1. Type [Ctrl] + [Alt] + [t] to open terminal on Ubuntu Host PC.
2. Enter the bootloader folder that you unzip.
3. Execute script to flash image.
$ sudo ./flashall.sh
4. Flash image complete.
e.g.