atd models ATD003-00 User manual

ATD003 - OO (1:76 Scale)
Timber Fence with Concrete Posts
(Brown) - Instruction Manual
Tools Required
Modellers Knife (with a fresh blade)
Cutting Mat
Modelling Glue (we recommend roket card glue)
Fine Tip Applicator
Low-tac Masking Tape
Clips / Clamps
Tips
Prior to starting your build, we recommend reading through the instructions to
familiarise yourself with the build style of the kit.
We recommend painting any white edges as you remove the components from
the sheet to improve the nished look. We advise watercolour paints for the best
nish.
Each component is held in the sheet using score lines, indicated by a scissor
symbol. To remove the component from the sheet, carefully run the tip of your
modelling knife through the score line.
Remove each component as it is required to prevent losing or mixing it up with
another component.
Ensure that glue is distributed evenly and not too close to the edge as it may ooze
out when pressure is applied.
Use low-tac masking tape, clamps and weights to aid the assembly process.

1. Detach component A x1 (fence panel) and place it on your worksurface.
Then detach component B x1 (gravel board) and place it below the fence
panel, as per the illustration below.
2. Detach component C x1 (concrete post). Apply glue to one side and
position, as per the illustration below.
Continue to glue the posts in position - the amount will vary depending on
the length you require.
We recommend the posts are spaced 22mm apart.
Next, turn over the model and begin gluing the posts inline with the posts
on the opposite side.
3. Once you’ve reached your desired length, trim the fence panel inline with
the last post. Alternatively, you can extend the fence by butting up two
components and bonding them using a fence post that’s evenly distributed
across both components, as per the illustration below.
You have now completed the fence kit. We hope you enjoyed and
successfully built the kit! To view our other card kits, more products and nd
your local stockist, visit www.atdmodels.co.uk
We’d love to see photos of your nished models. Please send them to
[email protected] for a chance to be featured on our social media pages.
© Copyright ATD Models | All Rights Reserved