Atlantic Furniture MISSION User manual

READY
Page 1 of 3
Adult Assembly
ASSEMBLY INSTRUCTIONS
Before assembling your End Table, please read through these
instructions carefully. Familiarize yourself with the different parts.
MISSION END TABLE-CHARGING STATION
MISSION END TABLE-CHARGING STATION
AE
D
BF
C
Flat washer - 8 pcs Wooden Dowel 3/8 X 1 1/4” - 4 pcs
Wooden Dowel 1/4” X 1 1/4” - 4 pcs
Spare - 2 pcs Spare - 1 pc
Spare - 1 pc
JCB M8 - 4 pcs Wood Screw - 8 pcs
Spare - 1 pc Spare - 2 pcs
Allen wrench - 1 pc
NOTE: WE INCLUDE SPARE HARDWARE IN CASE THE JCB, WOODEN DOWEL OR WOOD SCREW ARE DAMAGED DURING ASSEMBLY.
PARTS LIST
01
02
03
04
TOP PANEL 1 PC
4 PCS
2 PCS
1 PC
LEG
SIDE PANEL
LOWER SHELF
01
02
04
03
03
ATTENTION! If you receive a damaged or defective item,
please contact Atlantic Furniture at [email protected] 1-800-955-3726 / M-F 9:00-5:00 EST

Page 2 of 3
Adult Assembly
Adult Assembly
Install wooden dowels (D)(E) into the locator
holes on (03)(04) as shown below.
Attach first side panel (03) to end table
aligning the dowels with the holes in the
apron. Be sure the panel is centered before
tightening the wood screw (F).
F
F
D
D
D
D
E
E
E
F
02
03
03
04
03
02
02
02
01
02
AA
BB
STEP 1
STEP 2 STEP 3
Attach the legs (02) to the top panel (01) as shown below using flat washers (A) and
JCB (B), tighten with Allen wrench (C).
note : panel in center
MISSION END TABLE-CHARGING STATION
A
B

Attach second side panel (03) the same as the first but place the lower shelf (04) in
position by aligning the wooden dowels with the holes in the side panel.
Apply presure to eliminate any gap between the lower shelf
and the side panel and fix in place using wood screw (F).
F
F
F
Page 3 of 3
Adult Assembly
Adult Assembly
04
03
Congratulations !
Your Mission end table charging station is now ready for use.
We recommend that you recheck that all screws are tight,
and that all parts are secure before use and periodically to ensure lasting Safety.
STEP 4
STEP 5
MISSION END TABLE-CHARGING STATION