Atmos Multi 24/80+ User manual


0DQXDOIRUWKH$WPRV0XOWL%RLOHUV

3URSDQH&RQYHUVLRQ
Atmos Multi 07.99.91.711.0




3RVLWLRQV
A Screws to lock the casing
B Casing Latches
C Gas injector
D Nozzle
E Gas valve
F Adjusting screw
G Measurement gas pressure



0RGLILFDWLRQ5HTXLUHPHQWV
To convert from natural gas to propane, the following
components are required:
• 1 Gas injector of correct size (see WDEOH)
• Reference data
• 2 Propane stickers
 2SHQLQJWKH%RLOHU
1. Switch off the power to the boiler,
2. Remove the two screws in the control panel (A),
3. Unclip the casing latches (B) and remove the
casing from the appliance,
&RQYHUWLQJWKHERLOHU
1. Unscrew the brassnut on the gas valve and
remove the nozzle,
2. Check the marking on the new injector is as the
data on table I below,
3. Fit the new injector (C)in the mixing chamber.
4. Reassemble the gas nozzle (D) to the gas valve,
not forgetting the sealing ring,
5. Adjust the appliance to the correct settings.


  
Gas injector code 24 P 32 P
Injector Diameter ∅(mm) 4,0 4,4
Nom. Power Low fire (kW) 7,5 10,0
CO2-Low fire % 8,3 8,3
O2- Low fire % 6,0 6,0
Nom. Power High fire (kW) 25 32,7
CO2- High fire % 9,2 9,2
O2- High fire % 4,5 4,5

7DEOH, 3URSDQH%RLOHUN:



0DQXDOIRUWKH$WPRV0XOWL%RLOHUV

3URSDQH&RQYHUVLRQ
Atmos Multi 07.99.91.711.0
 *DV$LU6HWXS
The gas air mix is set and sealed in the factory. Carry
out the following steps to reset the appliance for
propane gas.
 ,QVSHFWLRQRIORZDQGKLJKRXWSXW
VHWWLQJ
The appliance can be operated on low or high output
with the aid of the service programme code “$”.
Press the VHW button for 10 seconds, when the
display panel will show an [$],
• In the central heating display [;;] (a number)
will show (indicating the ionisation level at the
flame ionisation probe),
• [LL] Burner running at lowest output,
• [HH] Burner running at highest output,
• To scroll between the three codes use the Hot
Water On/Off button,
• To exit this programme press the Reset button
twice.
The following tests can be made:
• Ionisation level (The display should show a
greater value than 40)
• Flame picture (VHH,QVWDOODWLRQPDQXDO)
• Oxygen or carbon dioxide level [3.2]
 6HWWLQJV
• *HQHUDO
Gas pressure must be about 35 mbar (14 inch WG).
The gas - air mixture is adjusted at the gas valve (F).
• 7RROVUHTXLUHG
- Flue gas analyser to measure O2or CO2to an
accuracy of ± 0,5%
- Torx driver T40 anti tamper, eg the Apex 440-TX-40-H
or 5 mm hexagonal wrench.
• 6HWWLQJ
To re-adjust the combustion the following procedure
should be followed:
a) Remove the cap from the test hole of the flue
pipe.
b) Insert the flue gas analyser probe.
c) Remove the anti tamper cap (F) from the gas
valve using the Torx driver .
d) Set the burner to lowest output. Measure the
CO2/ O2readings. Adjust the gas regulator
valve, as required, to give the readings shown in
Note.
(ie clockwise to increase CO2/ decrease O2).
• :DUQLQJ
The condensate syphon must be filled with water to
obtain correct results. If it is empty flue gas will
discharge into the trap.
• 1RWH
Only small adjustments of the gas valve are required
to change the O2or CO2emissions.
On low output the O2or CO2readings should be set
to: - O26,0 ± 0,50 %
- CO28,3 ± 0,25 %
On high output the O2or CO2readings should be set
to; - O24,5 ± 0,50 %
- CO29,2 ± 0,25 %

 ,GHQWLILFDWLRQ/DEHOV
To identify the appliance as being propane gas fired
there are two new labels in the conversion pack
which must be fitted. (Pt Nos. 07.98.35.504)
• 2QH label must be stuck on the data plate to
indicate that the data no longer applies
• The other label must be stuck above the
service record label , which is on the front of
the hot water insulation jacket, and indicates
that the appliance has been converted to
propane.
• 1RWH
)RUIXWXUHVHUYLFLQJSOHDVHNHHSWKLVGRFXPHQW
ZLWKWKHRWKHUPDQXDOVRIWKH$WPRV0XOWL%RLOHU














$WPRV+HDWLQJV\VWHPV,
West March,
Daventry,
Northants, NN11 4SA
For assistance; Tel: [phone]
Fax: [phone]
E-mail: [e-mail]