Attwood Quasar 3200 User manual

Figure 1
3
®
Light Pole Base
3200 and 3500 Series Installation Instructions Attwood marine hardware, navigational lighting, bilge pumps, and other
marineaccessoriesarespecifiedmorethananyotherbrandbyAmerica’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS Form Number 69303 Rev. C 03-11
REQUIRED FOR INSTALLATION •Drill with 1/8" (3mm) and 1-1/16" (27mm) bits •Screwdriver •Three #8 stainless steel fasteners (not countersunk) • Deck Gasket for 3200 Base (Attwood #910411) or
non-silicone sealant
LOCATION If base is used for a red/green bow light, locate in an unobstructed area as far forward as possible. Center of the base must be aligned with the centerline of the boat. INSTALLATION 1. On boat centerline, mark and drill 1-1/16" (27mm) diameter hole. 2. Insert base into hole with hinge toward bow. Align center screw
hole with boat centerline. Mark location of all 3 screw holes. Remove base.
3. Drill 1/8" (3mm) pilot holes. © 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com 4. Bring 12VDC (+) and (-) wires up through deck hole. Connect
wires to base using 1/4" spade connectors.
5. Apply deck gasket or non-silicone sealant to underside of base. 6. Align and fasten base with #8 stainless screws. Do not over tighten.
•
• •
•
#8 Stainless Steel Fasteners Quasar Light Pole Base Deck Gasket or Non-Silicone Sealant
1/4" Spade Connectors
•
Boat Centerline
Bow