Audifon Sueno Pro User manual

Sueno Pro Quick Start Guide
Inserting Batteries
1) Remove a battery from its packaging, remove battery tab and
allow the battery to sit for a few minutes to activate.
2) Push the battery door up until it clicks, you should then be able to open it fully.
3) Place the battery in the battery compartment, ensuring the + symbol on the
battery matches the + symbol on the battery compartment.
Please do not open
the battery door any
wider than shown
here. This might
damage the device.
4) Push the battery door up until it clicks shut.
Power On Delay
Your device will be ready for use 6 seconds after initial switch on.
Multi-Function Rocker Switch
Your device is fitted with a multi-function rocker switch, used to control the
programs & volume. The switch features 2 buttons, one at the top , and one
at the bottom .
These buttons can be operated in 2 different ways a long press is used for
program changes, a quick press is used for volume changes.

Volume Control
Programs
Your device is supplied pre installed with 3 included programs:
To change programs, long press the multi-function rocker switch on the top to
change in order 1 - 2 - 3 or bottom to change in reverse 3 - 2 - 1.
1) White Noise 2) Pink Noise 3) Waves
To control the volume, quick press the multi-function rocker switch on the top
for volume up or bottom for volume down.
Battery Information
For information on how to change batteries see user guide
pages 10-11 (Sueno Pro S) & 20-21 (Sueno Pro R).
Fitting Of The Reciever Unit (Sueno Pro R)
Select a receiver unit (lengths 1 or 2) according to the size of
your ear. Slide the unit onto the RIC housing until you hear a click.
Installation Removal
Installation
To remove the receiver unit, take hold of it between your thumb
and forefinger and pull it off the RIC housing carefully.
Removal
Fitting Of Tubing (Sueno Pro S)
Installation Removal
Thin tubes are installed onto the device using a threaded
connection, turn the tube clockwise to install.
Installation
Thin tubes are removed from the device using a threaded
connection, turn the tube anti-clockwise to remove.
Removal
Version 1.0