Audiovox AA923-AA94BT Owner's manual

TRANSMITTER PROGRAMMING GUIDE
YOu NEED TO PROGRAM BOTH TRANSMITTERS AT THE SAME TIME
1. The main harness connector should be disconnected from the siren
control module at this step of the installation procedure. If it is not,
unplug the connector .
2. Be sure to have both keychain transmitters in hand, then plug the
main harness connector into the siren control module. You should
hear a short "chirp" from the siren.
3. Press and hold the arming button on the existing allready
programmed transmitter until the siren sounds "onelong "chirp".
4. Immediately press and hold the arming button on the second
transmitter until the siren sounds one long "chirp".
5. Both transmitters should now be programmed. You can test this by
pressing the arming button on each transmitter, which will result in
the appropriate " ARMED" or "DISARMED" indication from the
siren.
IMPORT ANT! If only one transmitter is operating, repeat the
programming procedure. Once the harness connector is plugged in, you
have only 15 seconds in which to program both transmitters. This short
time window is required in order to provide a high level of security .
TRXPRG
TRXPRG