Avermedia AVerVision M50 User manual

M50
QuickGuide
1.Set the TV-RGB Switch Setting
A. RGB outputs the signal to RGB and DVI-I OUPUT port of M50.
B. TV outputs the signal from RS232/CVBS port thru RCA connection.
2. Connect the Video Output Display
A. RGB Connection
(1) RGB Cable (2) LCD/DLP Projector
(1) (2)
B. TV Connection
(1) RS-232/CVBS Cable (2) RCA Cable (3) RCA to SCART Cable
(Not supplied) (4) Television
(1)
(3)
(2)
VIDEO
SCART
INPUT
(4)
3. Connect the Power
(1) Power Adapter (2) Power Cord (3) Wall Outlet
(2)
(1)
(3)
4. Set the OSD Language
Press MENU, select SYSTEM > LANGUAGE, then press ENTER and
choose the language setting you prefer.
5. Connect a Computer to Show Computer Presentation
(1) RGB Cable (2) Laptop (3) Desktop
(1) (2) (3)
6. Connect via USB to Transfer the Captured Image to a PC or
Use M50 as a USB Camera with the bundled software.
(1) USB Cable (2) Laptop (3) Desktop
(1) (2) (3)

M50
QuickGuide
7. Basis Operation
zPress to zoom in and
to zoom out the image.
zPress to adjust the focus
automatically.
zPress CAMERA/PC to switch
between Camera and Computer
mode.
For laptop, make sure to switch
the output display to an external
video output device. Refer to the
laptop keyboard command
(FN+F5) to switch between
display outputs.
zPress to view the captured
image from the memory.
To start slide show, press SLIDE
SHOW on the remote.
zPress to pause or resume
the live image from the camera
or stop video playback.
zPress to capture and save
the image in the built-in memory.
In playback mode, use this to
delete the selected file.
zPress to start/stop audio &
video recording with either USB
flash drive or SD memory card.
If USB flash drive is used, make
sure switch is set to the
right.