Avermedia AVerDiGi EB3004 MD Use and care manual

EB3004 MD – Firmware Update Procedure
Page 1/6
1. Download and e tract the .ZIP file containing the latest firmware to a local
folder on your PC
2. Connect the RS232 cable to your PC’s desired COM port

EB3004 MD – Firmware Update Procedure
Page 2/6
3. Connect the 3 lines of the RS232 cable to the DVR unit as shown in the
picture below
RED – TX
GREEN – RX
BLACK - G
4. Power off the DVR unit by removing its power cord

EB3004 MD – Firmware Update Procedure
Page 3/6
5. Start the update program “C2B2_ISP.EXE” – the following window will
appear – select the COM-port from the dropdown list
6. Click the button “Identify”
7. Power on the DVR unit by plugging in the power cord

EB3004 MD – Firmware Update Procedure
Page 4/6
(The DVR will show the following screen and switch to FW upgrade mode)
8. Click the button “Read File” and select the new firmware file

EB3004 MD – Firmware Update Procedure
Page 5/6
9. Click the button “Program” to initiate the update process
During the update process, the DVR will display the following screen – do not
turn off your DVR, or interrupt the connection
10. After the update procedure is completed the following windows will appear
on your PC and DVR

EB3004 MD – Firmware Update Procedure
Page 6/6
11. The DVR will reboot automatically and display the newly installed firmware
version in the boot up self test
12. The FW update procedure has been completed
13. You may remove all the cables connected previously