AVstumpfl CURVE Manual

www.AVstumpfl.com Edition 1.13
CURVE - SETUP INSTRUCTIONS
CURVE - AUFBAUANLEITUNG

2
2
3
4 5
6
7
8
9 10
1
AufbAuAnleitung
Set up inStructionS

3
11 12 13
AufbAuAnleitung
Set up inStructionS
INSTRUCTIONS
Required tools: 3-5 ladders, 4mm Allen key
1-2 Assemble the upper and lower horizontal elements according to the numbering and fasten
them (1 Nm) 3-4 unfold the lateral vertical elements and plug them with the lower horizontal cor-
ner elements according to the labeling and tighten the thread bolts with the allen key 5-7 unfold
the center support and bolt them to the lower horizontal frame section according to the labeling
with the enclosed wing screws 8-9 attach the upper frame section to the top end of the vertical
frame sections with at least 3 people
10-12 unfold the projection surface with, according to the screen size appropriate number of
people and hook it onto the rail of the upper horizontal frame section and slide it with several
people gently till the opposite corner. 13 Now attach the snap fasteners on the lateral sides.
To attach the hooks to the lower frame bar easily, it is recommended to set up the projection
screen on T-Legs, or at least to raise the screen a bit with squared timbers.

www.AVstumpfl.com
AV Stumpfl GmbH I A 4702 Wallern I Mitterweg 46
AVstumpfl@AVstumpfl.com I www.AVstumpfl.com
tel.: [phone] / 42811 I fax: [phone] / 42811-4
Änderungen dienen dem technischen Fortschritt und bleiben vorbehalten.
We reserve the right to make modifications in the interest of technical progress.