Axion STIM-PRO Comfort User manual

INSTRUCTION MANUAL
STIM-PRO Comfort
axion GmbH
Mollenbachstr. 13
71229 Leonberg
Germany
2460
V 1.1

The primary functions of the STIM-PRO Comfort are pain
relief and pain treatment with the TENS mode.
What is pain?
Pain is a warning system and the body’s method of telling
us that something is wrong. Without it, abnormal conditions
and injuries to vital parts of the body may go undetected. A
persisting (long-term) pain is known as chronic pain. Pain
occurs when information signals travel to the brain via
nerve fibres, where it gets decoded, analyzed, and then
reacted to. The pain information travels from the injured
area along small nerves leading to the spinal cord. Here it
travels up the spinal cord to the brain. The information is
then interpreted, referred back and the pain is felt.
What is TENS?
TENS = Transcutaneous Electrical Nerve Stimulation, uses
tiny electrical impulses sent through the skin to the under-
lying nerves. TENS does not cure any physiological problem;
it only helps control the pain. TENS does not work to the
same extent for everyone; however, most patients report
that it is eective in reducing and even eliminating the pain.
It should only be used on medical advice or by prescription.
How TENS works
TENS can be applied in two operational modes:
The constant and weak activity with high frequency can block
the transmission of the pain signals from reaching the brain.
The brain cells process the pain signal. If the pain signal does
not reach the brain, no pain is felt. The second operational
mode of TENS is for the purpose of stimulating the body’s own
INTRODUCTION
INTRODUCTION
2
AXION
EN

natural pain control.
The “Burst”-mode (B) in a lower frequency may stimulate the
organism, so that analgesic substances are set free which
are called endorphins. For further details please refer to your
doctor.
Each STIM-PRO Comfort is fully equipped with the following
standard equipment.
1 piece TENS machine
4 pieces Self-adhesive electrodes
1 piece 9V battery
1 piece Storage case
2 pieces Electrode cables
1 piece Instructions manual
Scope of delivery
3
STIM-PRO Comfort
EN

GENERAL DESCRIPTION
SAFETY INFORMATION
The device is a battery-operated pulse generator that trans-
mits electrical impulses via electrodes to the body. These
impulses reach the nerves and muscles through the skin.
The electronics of the STIM-PRO Comfort creates electrical
impulses that can be modified in intensity, pulse duration and
frequency. All functions are easy to handle and the big dis-
play shows all parameter values clearly readable.
Read the instructions carefully before using the device.
Keep this device out of the reach of children.
Do not place electrodes in the area of the carotid arteries!
Do not place electrodes on the front of the throat!
Be careful with stimulation over metal implants.
User with an implanted electronic device like pacemakers
should only use the device under medical supervision.
Do not place electrodes above your heart!
Use with caution during pregnancy. Consult a doctor first!
Do not use electrodes on open wounds / injuries.
Do not use if you have fever.
Do not use if you have arrhythmia.
Do not use if you have epilepsy.
Never use the device when you are operating machines.
Never use near explosive or flammable gases.
Always TURN OFF the device before placing / removing
electrodes.
4
AXION
EN

Power On/O switch and intensity controls
The device can be switched on and o by turning the
intensity controls. The intensity can be increased by turning
the intensity controls clockwise and decreased by turning
the intensity controls counter-clockwise. The intensity can
be adjusted from 0 to 80mA. The display lights up as soon
as the device is turned on.
Program control
There are 9 TENS programs available. They can be selected
by pressing the button “program”. The program is activated
automatically 3 seconds after selecting the program.
Timer
The device has a timer that can be adjusted for 15, 30, 45
and 60 minutes as well as continuous mode (C). The
application ends automatically when the timer runs out.
Low battery indicator
If this symbol is shown, the battery is low and needs to be
replaced.
OPERATING THE DEVICE
5
STIM-PRO Comfort
EN

Program mode (P)
TENS programs P1 - P4
P 01 Frequency modulation
For most cases of chronic pain. Anti-habituation eect for
long-term applications. Choose a convenient
intensity.
Pulse frequency: modulated from 5 - 125 Hz
Pulse width: 120 μs
Application time: 30 - 60 minutes as needed
P 02 Classic TENS – gate control eect
For most cases of acute pain. Usually takes eect quickly.
Choose a convenient intensity.
Pulse frequency: 80 Hz
Pulse width: 80 μs
Application time: 30 - 45 minutes as needed
P 03 Burst TENS
For acute pain. Choose high intensity.
Pulse frequency: 2 Hz
Pulse width: 200 μs
Application time: 30 - 45 minutes as needed
P 04 For pain and tensions in neck and cervical spine area
Choose a convenient intensity.
Pulse frequency: 80 Hz
Pulse width: 120 μs
Application time: 15 - 45 minutes as needed
All parameters are set by default.
The programs have proven to be helpful in most cases for the
suggested applications. However, they might be used for the treatment
of other injuries or discomforts as well. Every patient responds
individually to stimulation current.
TENS STIMULATION
6
AXION
EN

TENS programs P5 - P9
P 05 For pain in thoracic spine and shoulder
Ideal for longer treatments. Anti-habituation
factor can be reduced by the strong pulse width change.
Choose a convenient intensity.
Pulse frequency: 100 Hz
Pulse width:: 60 - 200 μs
Application time: 45 minutes
P 06 For pain in lumbar spine and lumbago
Massage eec. Choose a convenient intensity.
Pulse frequency: 15 - 150 Hz
Pulse width:: 160 - 260 μs
Application time: 30 - 45 minutes
P 07 For pain in arm, elbow, tennis elbow, and carpal tunnel
syndrome
Choose a convenient intensity.
Pulse frequency: 24 - 80 Hz
Pulse width:: 180 μs
Application time: 15 - 30 minutes
P 08 Knee pain, osteoarthritis
For long-term treatments. For most pain indications, for
example in joints. Choose a convenient intensity.
Pulse frequency: 80/2 Hz
Pulse width:: 250 μs
Application time: 30 - 60 minutes
P 09 Ankle pain
Also for pain inn arms, legs, feet, muscular deep pain, and
sciatica.
Pulse frequency: 8 - 80 Hz
Pulse width:: 150 μs
Application time: continuously as needed
7
STIM-PRO Comfort
EN

Front
CONSTRUCTION OF THE DEVICE
Back
8
AXION
EN

When the low battery indicator is shown, the battery needs
to be replaced. Remove the battery if the device is not likely
to be used for some time.
Make sure the power is o.
Open the battery compartment (push the cover downwards)
Remove the battery
Insert the new battery. Please check that the polarity is
correct!
Close the battery compartment
BATTERY RECHARGING
9
STIM-PRO Comfort
EN

Non-flammable cleaning solution (containing 70% of
alcohol) is suitable for cleaning the device.
Stains and spots can be removed with a cleaning agent.
Do not submerge the device in liquids or expose it to large
amounts of water.
Return the device to the carrying box with sponge foam to
ensure that the unit is well-protected before transportation.
If the device is not to be used for a long period of time,
remove the battery and put it back into the carrying box
and keep it in a cool, dry place.
The packed TENS device should be stored and
transported under the temperature range of -20°C
~+60°C, relative humidity 20% ~ 95%, atmosphere
pressure 500 hPa ~ 1060 hPa.
For safety reasons, review the following checklist once a week.
Check the device for deformation of the housing or
damage to the output sockets.
Make sure that the descriptions and labels are not damaged.
Check that the LED is on when the device is turned on.
Check the cables and electrodes for damage.
MAINTENANCE, TRANSPORTATION
AND STORAGE OF THE DEVICE
SAFETY CHECKS
10
AXION
EN

Should any malfunctions occur while using your device, check
the following points. If none of these can solve the problem,
please contact the customer service.
Check if the cables are correctly connected to the device.
The display does not turn on? Replace the battery.
Check the cables for possible damage. The device may only
be used when subjected to a load.
There is no stimulation current? Check if the electrodes are
correctly connected to the same channel and if the intensity is
high enough.
The STIM-PRO Comfort device is in compliance with the
EN 60601-1-2:2007 and 60601-1:2006 safety standards.
The device must be subjected to safety checks and
maintenance by authorized technicians before use and
each re-use, but at least every 24 months.
Please consult your distributor if there are any problems
with the device and accessories.
The manual must always be carried with the device.
MALFUNCTIONS
CONFORMITY TO SAFETY STANDARDS
11
STIM-PRO Comfort
EN

01 Channel 2 channels with adjustable intensity
02 Intensity Adjustabl 0 - 80 mA with a load of 500 Ohm
on each channel
03 Pulse amplitude Asymmetrical, bi-phasic square pulse
04 Output Voltage 0 - 40 V
05 Power Source 1 pc. 9,0V battery
06 Size 10.0 cm (L) x 6.3 cm (W) x 3.2 cm (H)
07 Weight 124 g incl. battery
08 Program 1 Frequency: 5 - 125Hz
Pulse width: 120μs
09 Program 2 Frequency: 80Hz
Pulse width: 80μs
10 Program 3 Frequency: 2Hz
Pulse width: 200μs
11 Program 4 Frequency: 80Hz
Pulse width: 120μs
12 Program 5 Frequency: 100Hz
Pulse width: 60 - 200μs
13 Program 6 Frequency: 15 - 150Hz
Pulse width: 160 - 260μs
14 Program 7 Frequency: 24 - 80Hz
Pulse width: 180μs
15 Program 8 Frequency: 80 / 2Hz
Pulse width: 250μs
16 Program 9 Frequency: 8 - 80Hz
Pulse width: 150μs
17 Low battery
indicator
A low battery indicator will show up on the
LCD when the battery is low. Change the
battery.
18 Operating
condition
Temperature 0° C to 40° C
Relative humiditiy 30 % - 75 %
Air pressure 700 hPa - 1060 hPa
19 Notice All technical values include a tolerance
of +/- 5 %
TECHNICAL DESCRIPTION
12
AXION
EN

All TENS models carry a warranty of 24 months from the
date of delivery. The warranty applies to the stimulator
only and covers both parts and labor relating thereto. The
warranty does not apply to damage resulting from improper
handling, the failure to follow the operating instructions,
loss or dropping.
Manufacturer:
axion GmbH
Mollenbachstr. 13
71229 Leonberg, Germany
www.tens-ems.com/en
1. Advice for operation
2. Degree of electrical protection
3. Do not insert the plug into the power supply socket of 230V
4. Timer
5. Low battery indicator
6. Read the instruction manual
7. Direct current (DC)
8. Manufacturer
9. Serial number
WARRANTY
13
STIM-PRO Comfort
EN