Axminster PROFESSIONAL 103738 User manual

SUPPORT BAR
WITH DUAL AXIS
ADJUSTMENT
Code 103738
Original Instructions
Continues Over...
1
Terminology of the Support Bar
Back
Right
Front
Up
Down
Left
The ‘RED’ circles in figure (A) shows the
positions of the grub screws used to adjust
the support bar, to the side of the frame. The
‘GREEN’ circles in figure (B) shows the
position of the Hex head screws used to fix
the support bar to the side of the linisher.
A
B
Grub screw A Grub screw B
Grub screw C
Grub screw D
2
Setting the Jig
Loosen the two studs
Bar
Platen
Bar
Support Bar
These are the striations,
we call them sharpening lines
25mm

34
Loosen the two threaded studs holding the platen. Adjust the
platen so it projects out from the steel frame of about 0.5 to
1mm. Tighten the studs to secure the platen in place.
0.5 to 1mm
Clearance
Steel frame
Platen
Setting the Bar to the Platen
Ultimate Edge Angle Guage
The ‘Angle Gauge’ tool is a quick and easy way to accurately set
the correct clearence between the platen and the support bar.
The gauge has five preset stops from 20˚ to 40˚ degrees. The
gauge also incorporates a 25mm projection stop to set the
correct projection of the chisel out from the ‘Honing Guide’
assembly.
Method One Method Two
Using a digital leveling box check the suport bar is perpendicular
to the platen. Place the leveling box onto the bar, it should read
‘ZERO’ on the display. If adjustment is required, lightly loosen the
four Hex screws and adjust the support bar until the ‘Bar’ is in
line with the platen, nip up the Hex screws to secure the
assembly.
Linisher
Bar
Setting the Bar at 90˚ to the Platen
Hex screw
Alternatively place a 90˚ square on the bar and check its in line
with the edge of the platen and make adjustments accordantly.
Gap
Square to the
platen
Gap