Axxess AX-ADXSVI-GM1 User manual

Installation Instructions for AX-ADXSVI-GM1
(continued on next page)
AX-ADXSVI-GM1
WIRING THE AX-ADXSVI-GM1
• ConnecttheYellowwiretotheradio’s12voltbatteryormemorywire.
• ConnecttheBlackwiretotheradio’sgroundwire.
• ConnecttheRedwiretotheignitionwireoftheaftermarketradio.
• ConnecttheOrange wiretotheilluminationwireoftheaftermarketradio.Ifthe
aftermarketradiohasnoilluminationwire,tapeofftheOrange wire.
• ConnecttheBluewiretotheantennaturnonwireoftheaftermarketradio.
• ConnecttheWhitewiretotheleftfrontpositivespeakeroutputoftheaftermarketradio.
• ConnecttheWhite/Blackwiretotheleftfrontnegativespeakeroutputofthe
aftermarketradio.
BUICK
Enclave 2008-up
Lucerne 2006-2011
CADILLAC
Escalade 2007-2011
(only to be used when replacing an
amplified system)
DTS 2006-2011
(only to be used when replacing an
amplified system)
SRX 2007-2009
(only to be used when replacing an
amplified system)
CHEVROLET
Avalanche 2007-up*
CaptivaSport 2012-up
Cheyenne 2012-up*
Equinox 2007-2009
Express 2008-up
Impala 2006-2013
Impalalimited 2014
MonteCarlo 2006-2007
Silverado (new body)  2007-13*
Silverado2500/3500 2014*
Suburban 2007-2014*
Tahoe 2007-2014*
Traverse 2009-up
GMC
Acadia 2007-up
Savanna 2008-up
Sierra (new body)  2007-13*
Sierra2500/3500 2014*
Yukon/XL 2007-2014*
HUMMER
H2 2008-2009
PONTIAC
Torrent 2007-2009
SATURN
Outlook 2007-2010
Vue 2008-2010
SUZUKI
XL-7 2007-2009
APPLICATIONS KIT FEATURES
• Providesaccessory(12volt10amp)
• RetainsR.A.P.(retainedaccessorypower)
• Usedinnon-amplifiedsystemsorwhenreplacingamplifiedsystem
• ProvidesNAVoutputs(parkingbrake,reverse,andV.S.S.)
• PrewiredASWC-1harnessincluded(ASWC-1soldseparately)
• Highlevelspeakerinput
• USBupdatable
Note:
1) ThisharnessmustbeusedinconjunctionwiththeAX-ADXSVI
2) Allchimeswillbelostwhenusingthisharness
*Non-navigation models only

AX-ADXSVI-GM1
• Connectthe Gray wiretotherightfrontpositivespeakeroutputofthe
aftermarketradio.
• ConnecttheGray/Blackwiretotherightfrontnegativespeakeroutputofthe
aftermarketradio.
• ConnecttheGreen wiretotheradio’sleftrearpositivespeakeroutput.
• ConnecttheGreen/Blackwiretotheradio’sleftrearnegativespeakeroutput.
• ConnectthePurplewiretotheradio’srightrearpositivespeakeroutput.
• ConnectthePurple/Blackwiretotheradio’srightrearnegativespeakeroutput.
Thefollowingwiresarefortheaftermarketradiosthathavenavigationbuiltin.
• ConnecttheLight Greenwiretotheparkingbrakewireoftheaftermarketnavigation
radio(ifapplicable).
• Connectthe Blue/Pink wiretotheVSSorspeedsensewireoftheaftermarket
navigationradio(ifapplicable).
• ConnecttheGreen/Purplewiretothereversewireoftheaftermarketnavigationradio
(ifapplicable).
• Cyclethekey,byturningtheignitiononfor30seconds.Thenoffandonagaintotest
theradio.
ASWC-1 (if installing)
AftertheXSVIisinitialized,plugintheASWC-1intothe12-pinharnessoftheAX-ADXSVI-
GM1andrefertotheASWC-1instructions.
IMPORTANT WARNING
Thisproductincludesinstructionsforinstallationwhichmustbecarefullyfollowed.The
instructionsarewordedinsuchamannertoassumethattheinstalleriscapableof
completingthesetypeofelectronicinstallations.Ifyouareunclearastowhatyouare
instructedtodoorbelievethatyoudonotunderstandtheinstructionssoastoproperly
andsafelycompletetheinstallationyou should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and to install the interface as described
could cause harm to the vehicle or to safety systems on the vehicle. Interference with
certain safety systems could cause harm to persons as well.
If only the finest quality will do, then look no further than Axxess products. Accept no compromises, choose only quality OE integration interfaces.