Azden SGM-3416 User manual

SGM-3416/3416L
BROADCAST-SPEC SHOTGUN MICROPHONE
OPERATING MANUAL

2
Thank you for purchasing the Azden SGM-3416/3416L broadcast-spec shotgun microphone. Designed for
video and audio professionals, the SGM-3416/3416L is a super-direconal electret condenser microphone
with a wide frequency response and ultra-low noise levels. Each SGM-3416/3416L is tested before leav-
ing the factory and accompanied by its own frequency response chart.
POWER
The SGM-3416/3416L is powered by external Phantom Power. To power the unit, connect an XLR cable
(not included) to the microphone with a voltage source that supplies between 11 and 52 VDC.
MIC OUTPUT
The SGM-3416/3416L has a balanced 3-pin XLR output and will work in any impedance microphone input
of 1K ohm or less. Due to the wide variety of possible connecons and equipment used with the SGM-
3416/3416L, an output cable is not supplied.
WIRELESS OPTION
The SGM-3416/3416L can be turned into a wireless microphone by purchasing one of Azden’s unique XLR
plug-in transmiers and matching receiver. For more details, contact your Azden dealer or visit our web-
site at www.azdencorp.com
SHOCK-MOUNT HOLDER
The SGM-3416/3416L is supplied with a shock-mount holder and a replacement boom plate for boom
pole/tripod. Push the barrel into the clips unl it is secured. To secure the holder to a camera shoe, slide
the older into the camera shoe and ghten the thumb wheel by turning it clockwise unl it is ght. To
mount the SGM-3416/3416L onto a boom pole or tripod, replace the boom plate of the shock-mount
holder with the supplied boom plate with a 3/8” threaded hole and screw the holder to a boom pole/
tripod by turning it clockwise.
Balanced 3-pin XLR output
Shield
Cold
Hot

3
180/247mm
SPECIFICATIONS
SGM-3416
Type: Electret condenser
Frequency response: 40—20,000Hz
Sensivity: Uni-direconal, -33dB at 1kHz (0dB=1V/Pa)
Impedance: 120Ω at 1kHz
Max SPL input level: 115dB SPL (1kHz at 1% T.H.D)
Signal to noise rao: 78dB (1kHz at 1Pa)
Power source: Phantom DC 11-52V
Weight: 125g (4.4oz)
Dimensions: ɸ19mm x 180mm (ɸ3/4” x 7”)
Connector: Balanced 3-pin XLR
SGM-3416L
Type: Electret condenser
Frequency response: 40—20,000Hz
Sensivity: Uni-direconal, -33dB at 1kHz (0dB=1V/Pa)
Impedance: 120Ω at 1kHz
Max SPL input level: 115dB SPL (1kHz at 1% T.H.D)
Signal to noise rao: 78dB (1kHz at 1Pa)
Power source: Phantom DC 11-52V
Weight: 160g (5.64oz)
Dimensions: ɸ19mm x 247mm (ɸ3/4” x 9 3/4”)
Connector: Balanced 3-pin XLR
FREQUENCY RESPONSE POLAR PATTERN
FREQUENCY RESPONSE
POLAR PATTERN

4
TWO-YEAR WARRANTY
Azden Corporaon warrants, to the rst purchaser, that the Azden brand product purchased is free from
defects in material and workmanship. Azden’s sole obligaon under this warranty shall be to provide,
without charge, repair or replacement (at Azden’s sole discreon), within two years from the date of
purchase. The cost to ship a failed product to and from Azden or to its dealer shall not be covered by
this warranty. A dated receipt acts to establish the date of purchase.
This warranty is the sole and exclusive express warranty given with respect to the product and all other
warranes, expressed or implied, are hereby excluded. Neither Azden, nor the dealer who sells this
product, is responsible for indirect, incidental or consequenal damages.
This warranty does not extend to any defect, malfuncon or failure caused by misuse, abuse, accident,
Act of God, faulty hookup, unauthorized modicaon, connecng this product to equipment for which
this product is not intended or defecve associated equipment. Please read your owner’s manual care-
fully.
To register this product, please visit www.azdencorp.com/warranty
AZDEN CORPORATION
147 New Hyde Park Road, PO Box 10, Franklin Square, NY 11010
Phone: [phone] Fax: [phone] Email: [e-mail]