Azden SGM-PII User manual

SGM-PII
OWNER’S MANUAL
Professional
Phantom-Powered
Shotgun Microphone
Customers in the North/South America and Europian markets contact:
Azden Corp., 147 New Hyde Park Rd, P.O. Box 10, Franklin Square, NY 11010
voice - 516.328.7500 • fax - 516.328.7506 • email - [email protected]
© 2007 Azden Corporation
P1070-01 012-34295-01A
Printed in Japan
Customers in the Asian and Oceania markets contact:
Azden Corp., 1-12-17 Kamirenjaku Mitaka-shi, Tokyo, 181-8533 Japan
voice - 81-1-422-55-5115(Japan) • fax - 81-1-422-55-0131(Japan)
email - [email protected]
Azden Corporation warrants, to the first purchaser, that the Azden brand product
purchased is free from defects in material and workmanship. Azden's sole obligation
under this warranty shall be to provide, without charge, repair or replacement
(at Azden's option), within two years from the date of purchase. A dated receipt acts
to establish the date of purchase.
This warranty is the sole and exclusive express warranty given with respect to the
product and all other express warranties are herby excluded. Neither AZDEN, nor
the dealer who sells this product, is responsible for indirect, incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you.
This warranty does not extend to any defect, malfunction or failure caused by misuse,
abuse, accident, faulty hookup, unauthorized modification or defective associated
equipment for which it is not intended. Please read your owner's manual carefully.
This warranty gives you specific legal rights. You may also have other rights which
vary from state to state.
To register this product, go to www.azdencorp.com/warranty "for North/South
America and EU customers.
Asia/Oceania customers contact with Azden distributors listed on www.azden.co.jp/global.html
TWO-YEAR WARRANTY

Thank you for purchasing the Azden SGM-P II
microphone. Designed for video and audio pro-
fessionals, the SGM-P II is a uni-directional shotgun
microphone with a wide frequency response and low
noise levels.
Power:
The SGM-P II must be powered by Phantom-
Power. To power the unit, connect an XLR cable to
the microphone from a voltage source that supplies
between 11 and 52VDC. (see wiring diagram below)
MIC Output:
The SGM-P II has a balanced 3-pin XLR
connector.
Shoe-Mount Holder:
The SGM-P II is supplied with a camera-
mountable mic holder. Snap the near portion of the
microphone into the holder. To secure the holder,
slide the holder into the camera shoe and tighten the
thumbwheel by turning it clockwise.
SPECIFICATIONS:
Electret Condenser Microphone
Frequency Response 80-18,000Hz
Sensitivity –33dB at 1kHz (0dB=1V/Pa)
Impedance 130 Ohms at 1KHz
MAX SPL (Input Level) 120dB SPL (1kHz at 1% T.H.D)
Signal-To-Noise Ratio 70dB. (1kHz at 1Pa)
Power (Phantom-Power) 11 

52VDC
Current 

2.4mA
Weight 90g
3.6oz
Dimensions 21mm x 207mm
0.827 x 8.27 inches
Connector 3-PIN XLR
Supplied Accessories Shoe-Mount Holder,
Wind Screen, Pouch
Frequency Response Super-Cardioid Polar Pattern
Due to constant improvements, specifications are subject to change without notice.
Shield
Positive (Hot)
Negative (Cold)