Azden SMX-10 User manual

SMX-10 STEREO MICROPHONE INSTRUCTION MANUAL
Thank you for purchasing the Azden SMX-10 stereo microphone. The SMX-10 is designed for videographers that
require high quality stereo sound pick-up.
BATTERY:
Unscrew lower half of the microphone by turning the case
counter clockwise. Insert one AAA battery into the case.
Check for correct polarity. Replace the case and turn
clockwise to tighten. Do not over tighten or you may damage
the threads.
MICROPHONE HOLDER:
Snap the microphone into the holder towards the back of the case. Slide the holder onto the
shoe mount of the camera and tighten the wheel until snug. Do not over tighten or you may
damage the threads.
WINDSCREEN:
Slide the windscreen over the front end of the microphone and cover all the vents on the case.
OUTPUT CABLE:
Plug the microphones output cable into the “Ext. Mic” input jack on your camera.
POWER SWITCH:
Turn the microphone power switch to “ON” for normal operation.
When not in use turn the microphone “OFF” to avoid draining the battery.
LOW CUT FILTER SWITCH:
: Turn the low cut filter switch to “ON” to reduce low frequency sounds and increase clarity.
: Turn the low cut filter switch to “OFF” for flat response and maximum bass.
SPECIFICATIONS POLAR PATTERN
TYPE: Stereo Electret Condenser
Sensitivity: -40dB(at 1kHz 1V/Pa)
Frequency Response: 100 – 20,000Hz
Output Impedance: 1.5kΩ(at 1kHz)
Power Source: DC1.5V AAA size battery
Max.Sound Pressure Level: 100dB
Signal Noise Ratio: More than 60dB
Plug Cord Ass’y Coiled cord with φ3.5 plug
PRINTED IN JAPAN
1-12-17 Kamirenjaku Mitaka-shi Tokyo 181-8533 Japan
Tel :[phone] Fax :[phone]
E-mail : [email protected] URL http://www.azden.co.jp