Baby Jogger SUMMIT XC TRIPLE User manual

Read these
instructions carefully
before use and
keep them for
future reference.
Your child’s safety may be
affected if you do not follow
these instructions.
Assembly
Instructions
Summit XC Triple
Amazing 360° Turns
Make For Extreme Maneuverability

2
• WARNING: DO NOT exceed 3 mph – this stroller is not suitable for skating
or roller blading.
• WARNING: Prevent serious injury to your children by always using the
safety harnesses.
• WARNING: Parcels or accessory items, or both, placed on the unit may cause the unit
to become unstable.
• WARNING: Never leave your children unattended. Baby Jogger will not be held liable
for accidents/injuries related to leaving your child unattended.
• WARNING: Recommended weight for seat pocket is 2 lbs and basket is
10 lbs. Excessive weight may cause a hazardous unstable condition to exist.
• WARNING: Stroller is not meant to be used for transporting children up or down stairs.
Damage resulting to stroller, will not be covered under warranty.
• WARNING: Child may slip into leg openings and strangle. Never use in
reclined carriage position unless safety harness is properly fastened.
• Accessories which are not approved by the manufacturer or distributor
shall not be used.
• The passengers shall remain seated (no standing in the stroller).
• Watch out for cars – never assume that a driver can see you and your children.
• Total weight load recommended for this stroller is 125 lbs / 56.7 kg
(combined passengers and baggage weight).
• This stroller seats three passengers.
• It may be unsafe to use replacement parts other than those supplied or approved by the
manufacturer.
• DO NOT recline seats past point noted on recline label when running/jogging.
• DO NOT run/jog with children under 6 months of age in stroller seats.
The sample product shown in this manual may differ slightly from your production quality
Summit XC. However, this will not affect the assembly or functionality of your Baby Jogger product.
For the sake of your precious cargo, please read
these warnings before using your stroller.

1
1 Unpack stroller from box and set rear
wheels aside.
2 Pull handlebar up and away from
fork tips.
3 Lay stroller flat so that both ends are resting
on the floor. The stroller frame will click and
lock into place.
To fold: Unsnap safety strap from frame and pull up on fold strap.
4 Turn stroller over.
WARNING: Ensure all
locking devices are
engaged before use.
Frame

2
Front Wheels
1 To install front wheels, lay stroller back so the
handle is resting on floor.
2 Align the round openings on the tops of
the front forks with the round metal pegs
underneath the foot plate. Slide the front
wheels onto the metal pegs until they click
into place.
To remove the front
wheels, press down on
the levers on the top of
the front forks and slide
the wheels off.
Swivel/Straight Feature
Front wheel locking lever
Push down to lock front wheels.
Pull up to engage swivel wheels.

3
Rear Wheels
1 To install, gently slide the rear
wheel’s axle into the hole in
the frame until the wheel
clicks into place.
2 To remove, simply press
the wheel button while
gently sliding the wheel
away from the frame.

4
Seat
1 Secure seat fabric to
frame by lining up
snap placement on
frame and fabric. Start
at top snap and work
your way down frame
To fold stroller:
Remove child
from seat.
Unsnap safety
straps from
frame and pull
upwards on the
fold straps with
a gentle tug.
3 Secure safety straps to
both sides of the frame
before use.
4 Be sure that fold strap rings are secured to the
frame before use.
2 Secure seat straps around the bottom
of the frame, behind the front wheels.
Thread one seat strap through the
D ring of the other strap, and fasten
both Velcro sides firmly together.
WARNING: Always
be sure the safety
strap Is securely
snapped onto the
frame before using
stroller!

55
Reclining Seats
1 To recline: Pinch the clamp behind the seat, and slide it down to desired recline. Pull seat down
on both sides to match recline position of clamp.
Reverse steps to return to the upright position.
• Weather Cover: If desired, pull weather cover
down and over the seat back mesh. Secure
firmly over both sides of seat. When not in
use, roll weather cover up and fasten with
elastic loop and barrel provided under top of
the seat fabric.
WARNING: Do not recline
past point noted on recline
label when running/jogging.
WARNING: Do not run/jog
with children under 6 months
of age in stroller seat.

6
Safety Harness
WARNING: Always
use the crotch strap
in combination with
the shoulder straps
and waist belt.
1 Unclip top of shoulder strap from the seat and
re-clip on the pair of seat loops closest to your
child’s shoulder height.
2 To adjust the shoulder and crotch strap length:
Remove the shoulder pads and slide the plastic
guide up or down to lengthen or shorten.
3 To buckle the harness: Simply push side buckle
into center buckle until it locks into place.
To unbuckle: Push one side of the center
button and pull the corresponding side buckle
away from the center buckle. Repeat to
unbuckle other side.
WARNING: The shoulder straps must be over the child’s shoulders
and the lap belt section must be over the child’s lap. The harness
must be tightened so that the child is fully restrained yet
comfortable. As a guide, you should be leaving a gap of no more
than two finger widths between the harness and the child’s body.

7
Hand Brake
Brake
• Simply push
brake pedal down
to engage rear
parking brake and
lift up to release.
WARNING: Engage
parking device
before loading
and unloading
passenger.
1 To use the hand brake make sure brake pads
are properly installed (see page 3). Squeeze
the hand brake to give you better control over
your stroller while jogging or running.
2 To rotate the hand brake’s position on the
handle bar, loosen the bolt using the supplied
Allen wrench. Rotate the hand brake assembly
on the handlebar until it is in a comfortable
position. Tighten the bolt to secure hand brake.
Adjusting the hand brake: If you do not have
good braking action, simply squeeze the brake
handle (A) five or six times. If the problem
persists, loosen the brake’s cylinder ring (B) to
adjust the small ring (C) and then move the
small ring away from the handle to tighten the
cable. (Please do not over tighten!) To lock the
rings, tighten the cylinder ring (B) against the
handle while holding the small ring (C) in place.
• Your stroller is equipped with a hand brake
for your jogging convenience.
C
A
B

8
Canopies
2 To attach canopy to bracket: Insert canopy
frame into bracket and attach screws using
a Phillips head screwdriver.
1 To attach bracket to frame: Unsnap seat
from frame to reveal mounting location.
Use a Phillips head screwdriver to attach
bracket screws to frame.
4 Velcro canopy strap around frame to itself.3 Wrap straps around frame and
snap together.