Bake Max BMPM007 User manual

BMPM007
Operation Manual
7 Quart Planetary mixer

Our 7 liter mixer has a high 650 Watts power to allow mixing stiffer dough's and larger
batches.
All metal body and counter-top style is designed professionally.
Its shafts are mounted in ball bearing and 100% steel gears drive.
Electronic 5-speed control helps you to enjoy non-stop shifting speed.
Planetary mixing action and digital timer ensures perfect results. Simple hand lift is good
for changing bowl and attachments. When overloading, power off automatically to
protect motor and electrical.
Safety guard is ONLY FOR BMPM-007
Smoothly rotate open with a micro switch to shut off power immediately to protect
operator.

1-1 SAFETY PRECAUTIONS
When using this machine, always make sure the following conditions or operations are in effect.
Failure to this may cause accident or injury.
•Keep hand & clothing away from bowl and attachments when in operation.
•Keep rigid objects away from bowl and attachments when in operation.
•To protect against risk of electrical shock, do not immerse mixer in water or other liquid.
•Use the machine only with the electrical service specified on its nameplate.
•Disconnect the machine from its power source before carrying out any maintenance.
•Do not disable or remove the safety mechanisms included with the machine.
•Do not leave the machine in operation unattended.
•Observe maintenance and safety inspection schedules.
•Maximum bread dough capacity 1500 gram on basis of 60 percent water.

1-2 SPECIFICATIONS
Motor: 650Watts powerful, ball bearing, ventilated within mixer enclosure.
Electrical: 100-120V, single phase or 208-240V, single phase
Switch & Timer: All in one digital control panel
Cord and Plug: 6 feet flexible cord and plug (for 110 V model only), respectively consist
of 3 wires which one wire is connected for grounding, other wires are
connected to power supply.
Transmission: The gears are constantly meshed in a special lubricant assuring long life;
transmission gears are of heat-treated alloy steel, High accurate
construction. All bearings are ball bearings.
Speeds: The mixer has five positive speeds as 100 RPM -500 RPM
Safety Guard: Safety guard is ONLY FOR BMPM-007. Smoothly rotate open with a
micro switch to shut off power immediately to protect operator.
Dimension: 340 x 460 x 520 mm
L x W x H (13.4" x 18.1" x 20.5")
Net Weight: 18 Kg (39.6 lb.)
Standard: Stainless steel bowl: 1pc
Attachment: Mixing hook: 1 pc
Flat beater: 1 pc
Whipping ball: 1 pc

2. INSTALLATION
BEFORE INSTALL YOUR MIXER, CHECK TO BE SURE THAT YOUR
ELECTRICAL SERVICE SPECIFICATIONS MATCH THOSE OF YOUR
MIXER AS PRINTED ON THE MIXER'S NAMEPLATE.
2-1 LOCATION
Place the mixer in its operating location. Bench should be placed on a sturdy level surface. There should
be adequate space around the mixer for the user to operate the control and install and remove bowls.
2-2 ELECTRICAL CONNECTIONS (Cord Connected Mixers)
WARNING:
THIS SUPPLY CORD ON THIS MACHINE IS PROVIDED WITH A
THREE-PRONG GROUNDING PLUG IT IS IMPERATIVE THAT THE
OUTLET TO WHICH THIS PLUG IS CONNECTED BE PROPERLY
GROUNDED. IF THE RECEPTACLE IS NOT THE PROPER
GROUNDING TYPE, AN ELECTRICIAN SHOULD BE CONTACTED.
2-3 INSTALLATION DIAGRAM (MM)

3. OPERATION
Note: BEFORE being put into service. This cleaning procedure should also be followed for
bowls and agitators before whipping egg whites with or whole eggs.
3-1 CONTROLS
All models are furnished with a digital Timer and electronic 5-speed
Timer:
Digital set by 1-30 minutes or non-timer service.
Speed:
Speed 1 - For slow beating, mashing and kneading yeast dough. Speed 2 - For mixing cookie and
cake batters. Speed 3 - For beating, creaming and medium fast whipping. Speed 4 - For whipping
heavy cream, egg whites and boiled frostings. Speed 5 - For whipping small amounts of heavy
cream and egg whites.
3-2 HOW TO INSTALL AN AGITATOR
To install an agitator, the bowl must be installed and fully lowered. Place the agitator in the
bowl, push it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the
agitator shank.

3-4 HOW TO INSTALL A BOWL
The bowl must be installed before the agitator. To install the bowl, fully lower the bowl support.
Position the bowl so the alignment bracket on the back of the bowl is in the bowl retainer and the
locating pins on the front of the bowl support fit in the holes on the sides of the bowl.
3-5 ATTACHMENT USE GUIDE
DOUGH ARM:
It is frequently used for heavy bread dough, and preferable to be use at 1 speed
BEATER:
It is commonly used for thin batters, cake and mashing potatoes, like stuffing and
preferable to be used at 2-3 speed.
WHIP:
It is best for whipping cream and beating eggs and preferable to be used at 4-5
speed.
4. MIXING CAPACITY:
PRODUCT
TOOL
7 LITER BOWL
Egg Whites
Whip
700 g
Mashed Potatoes
Beater
1500 g
Mayonnaise (Qts. Oil)
Beater
3 liter
Meringue (Qts. Water)
Whip
1 liter
Waffle/Pan cake Batter
Beater
2 liter
Whipped Cream
Whip
3 liter
Sheet Cake Batter
Beater
2000 g
Layer Cake
Beater
2500 g.
Pound Cake
Beater
2500 g
Sugar Cookie
Beater
2500 g
Sponge Cake
Whip
1000 g
Dough, pie
Beater
1500 g
Bread or Roll Dough
Hook
Water
Flour
(Light/ Medium, 60% water)
1 speed
500 g.
800 g

WARNING:
Ensure your recipe meets mixers capacity.
Ensure water is 70 Degrees Fahrenheit or reduce capacity.
Ensure flour is at room temperature.
Ensure mixer is turned off when changing gears.
FAILURE TO COMPLY VOIDS ALL WARRANTY.

5. MAINTENANCE
NOTE: ALL MAINTENANCE WORK SHOULD BE DONE ONLY AFTER UNIT HAS BEEN
DISCONNECTED FROM ELECTRICAL POWER AND GROUNDING.
Never use a metal or stiff brush to clean the mixer. Never clean the mixer with a water hose or any
fluid pressure.
The mixer should be thoroughly cleaned after using.
Bowls and agitators should be removed from the mixer and cleaned.
The transmission case and planetary gears are filled special grease that will last for several years.
When grease is needed for replacement, it should be ordered from our authorized service
representative.
If the attachment strikes bowl, stop the mixer. The original seller will help you to make
adjustment.
If your mixer should malfunction or fail to operate, check the following.
Is the mixer plugged in?
Is the fuse in the circuit to the mixer in working order? If you have a circuit breaker box, be sure
the circuit is closed.
If the problem is not due to one of the above items, please contact your
original seller.