Baldwin 009 Series User manual

CYLINDER COLLAR
G
G
G
G
SERIES SHOWN
Instructions for converting Entry to Night
latch function
Entry function can be converted to Night latch function by inverting the cam on the mortise cylinder.
The steps below show how to invert the cam:
Step # 1:
Locate cam and cam screws on the
back of the mortise cylinder.
Step # 2:
Remove the two cam screws and
the cam.
Step # 3:
Rotate cam 180 degrees and re-install
in the down position.
Re-install and tighten the cam screws
being careful not to over tighten them as
overtightened screws will make mortise
cylinder difficult to operate.
Step # 4:
Follow directions for installing cylinder
into trim.
Cam
Cam Screws
Do not insert the key while converting function.
SPRING SPINDLE
Insert spring in spindle hole to
extend the length of the spindle
if required.
2010.03A
009
Series

2 13/16"
1 19/32"
1 19/32"
C or D
G
C or D
NOTE:(A) 4 G HOLES ARE FOR HEAVY DUTY SERIES USE. (B) C & C or D & D ARE FOR STANDARD SERIES USE.
NOTE:(A) 4 G HOLES ARE FOR HEAVY DUTY SERIES USE. (B) C & C or D & D ARE FOR STANDARD SERIES USE.
2 7/32"
G2 7/32"
For HEAVY DUTY G holes.
For STANDARD
4. FOR HEAVY DUTY SERIES SCREW
THRU BOLTS INTO (4) G HOLES & FOR STANDARD SERIES SCREW THRU BOLTS INTO EITHER C&C FOR LHR OR D&D FOR RHR AND TIGHTEN.
5. IF CYLINDER IS REQUIRED, INSTALL CYLINDER INTO CYLINDER HOLE WITH CYLINDER COLLAR AND SECURE WITH CYLINDER RETAINING RING. 7. PROCEED WITH TEMPLATING DOOR AS SHOWN IN FIG 7 AND FIG 9 FOR EITHER HEAVY DUTY OR STANDARD SERIES.
2 13/16"
2 5/32” 2 5/32”
2 5/32”
2 5/32”
2 15/16" 2 15/16"
9 3/32"
2 15/16"
9 3/32"
2 7/16"
9/16"
3/4”