B&B Electronics EIR41x-2SFP Series User manual

EIR41x-2SFP Series-1012qsg
Quick Start Guide
Elinx Gigabit Ethernet Switch
EIR41x-2SFP Series
Items Included
1
2
Hardware Installation
3
LED Chart
4
Ports
5
Installation Complete
oEthernet Switch
oCD with Support Manual
oThis Quick Start Guide
oPanel Mount Bracket
1. Select a mounting location and install the
switch onto a piece of DIN rail or use the
included panel mount brackets for wall or
panel mounting
2. Connect power to the switch
12 to 48 VDC
If redundancy is desired be sure to
connect two separate power supplies by
using the two DC inputs on the terminal
blocks
If only one power input is used the Fault
LED will light (this is normal)
RJ-45 ports: The RJ-45 ports auto-sense for 10, 100 or 1000
Mbps devices connections. The auto MDI/MDIX feature
allows connections to switches, workstation and other
equipment without changing straight through or crossover
cabling. The charts below show the cable pin assignments
for straight through and crossover cables.
LED Status Description
Green Power 1 is active
PWR1 Off No power at input 1
Green Power 2 is active
PWR2 Off No power at input 2
Red PWR1 or PWR2 has failed
Fault Off PWR1 & PWR2 are both active
or no power is applied
Green Connected to network
Blinking Networking is active
10/100
Copper
Upper LED Off Not connected to network
Yellow Full duplex operation
Blinking Collision of packets occurs
10/100
Copper
Lower LED Off Half duplex or no connection
Green Connected to network
Blinking Networking is active
Gigabit
Copper
Upper LED Off Not connected to network
Green Operating at 1000M
Gigabit
Copper
Lower LED Off
Operating at 10/100M or disconnected
Green SFP port is connected to network
Blinking Networking is active
SFP
Link/Active
(100/1000) Off Not connected to network
MDI Cable Pinout
Pin Signal
1 Tx+
2 Tx-
3 Rx+
6 Rx-
MDI-X Cable Pinout
Pin Signal
1 Rx+
2 Rx-
3 Tx+
6 Tx-
1. Auto MDI/MDI-x is
supported. A straight
through or cross-over
cable may be used.
2. 10/100/1000 auto
negotiation and full/half-
du
p
lex are su
pp
orted.
1. When the network cables are attached and power
is applied, installation is complete.
2. The switch will automatically discover network
devices, populate its MAC address table, and
pass traffic to the appropriate ports.