Bayco NightStick XPP-5454G User manual

Instruction Manual
XPP-5454G
US PATENT 9,713,217
THE XPP-5454G IS APPROVED FOR USE
CLASS I DIV 1 GRPS A-D T3
CLASS II & III GRPS E-G T135ºC
CLASS I ZONE 0 AEx ia IIC T3 Ga
Ex ia IIC T3 Ga
II 1 G Ex ia op is IIC T3 Ga
Ex ia op is IIC T3 Ga
Intertek ITS 13 ATEX27928X
IECEx ITS 18.0030X
-20ºC ≤ Tamb ≤ +40ºC
1.5V/Cell E92 or EN92
0359
ID 5012927
INTRINSICALLY SAFE
SECURITE INTRINSEQUE
Bayco Products, Inc. XPP-5454G
640 S. Sanden Blvd., Wylie, TX 75098
Conforms to:
ANSI/UL STD 913, ANSI/UL
60079-0, ANSI/UL 60079-11
Certified to:
CAN/CSA STD C22.2 No 157
CAN/CSA STD C22.2 No 60079-0
CAN/CSA STD C22.2 No 60079-11
CSA STD C22.2 No 25
INMETRO
Segurança
NCC
Ex ia op is IIC T3 Ga
(-20ºC ≤ Tamb ≤ +40ºC)
15.0296 X
WARNINGS - INTRINSICALLY SAFE
yWarning: Use only the approved non-rechargeable batteries listed below.
yWarning: Do NOT attempt to use rechargeable AAA batteries with this light.
yWarning: To prevent ignition of a hazardous atmosphere, do not open the battery
compartment in the hazardous environment. This task must ONLY be performed in an
area known to be non-hazardous.
yWarning: When exchanging batteries, use only ENERGIZER E92 or EN92
BATTERIES.
yWarning: To prevent ignition of a hazardous atmosphere, the AAA batteries must
only be exchanged in an area known to be non-hazardous.
yWarning: To reduce the risk of explosion, do not mix new non-rechargeable batteries
with used non-rechargeable batteries, or mix non-rechargeable batteries from different
manufacturers.
yWarning: Substitution of components may impair intrinsic safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
yFor personal safety, always con rm the rating of any known hazardous or potentially
hazardous location where the light is to be used.
BATTERY INSTALLATION
WARNING: In order to maintain the XPP-5454’s Intrinsically Safe rating, the only
AAA batteries certi ed for use with this light are the ENERGIZER E92 or EN92
BATTERIES.
yDo not attempt to use any other brand or model of AAA batteries with this light.
yDo not attempt to use any type of rechargeable AAA batteries with this light.
Warning: To prevent ignition of a hazardous atmosphere, do not open the battery
compartment door in the hazardous environment. This task must ONLY be done
in an area known to be non-hazardous.
yLoosen the locking screw located on the back of the battery compartment door.
NOTE: Do NOT attempt to completely remove the locking screw. Doing so is not
necessary and may damage the threads. The screw simply needs to be loosened
enough to allow the battery compartment door to open.
yUsing 3 – AAA ENERGIZER E92 or EN92 BATTERIES (make sure that all 3
batteries are of the same model), install the batteries in the back of the light paying
close attention to the markings inside the battery compartment for proper battery
terminal polarity alignment.
yClose the battery compartment door.
yTighten locking screw. CAUTION: Do NOT over-tighten. Doing so may damage the
threads and impact the light’s Intrinsic Safety.
OPERATION
THE XPP-5454G HAS TWO BUTTONS THAT CONTROL LIGHT OUTPUT:
LIGHTING MODES
Pressing the Spotlight Button will turn on the spotlight. Pressing the Floodlight
Button will turn on the  oodlight. Pressing both buttons will turn on both the Spotlight
and the Floodlight. This mode is called Dual-Light.
EACH BUTTON HAS TWO BRIGHTNESS SETTINGS
yHigh-brightness - Press the desired button once
yLow-brightness - Press the desired button a second time
yPressing the same button a third time will turn that lighting mode off
THE XPP-5454G HAS A TILT ADJUSTMENT FEATURE:
Simply adjust the tilt angle of the light to illuminate the desired area.
THE XPP-5454G COMES WITH TWO DIFFERENT HEADBANDS:
ELASTIC NON-SLIP HEADBAND
Use this headband for wearing the headlamp directly on your head or while wearing
a soft hat such as a ball cap. The non-slip feature will keep the light positioned on the
head even during vigorous movement.
HEAVY-DUTY RUBBER HEADBAND
Use the heavy-duty rubber headband on any hardhat. The tacky nature of the strap
will keep the light attached even if the hat is dropped or used in wet conditions.
XPP-5454G

EU Declaration of Conformity (DoC)
XPP-5454G / XPP-5454GC
Company name
Postal address:
Postcode and City:
Bayco Products
Declare that the DoC is issued under our sole responsibility and belongs to the following product:
Apparatus model/Product:
XPP-5454G / XPP-5454GC
Type: Flashlight
ATEX Directive 2014/34/EU
The following harmonised standards and technical specifications have been applied:
Evaluated to the following safety standards by Intertek:
EN 60079-0:2012/A11:2013 EN 60079-11:2012 (ia) EN 60079-28:2015 (op is)
These Products are fully compliant and do not contain the restricted substances above levels noted in EU
RoHS.
Certificate No. ITS13ATEX27928X/2
Name James Conner
Engineer
Date of issue:
Form F-900-001 Rev-B
Looking for dependable headlamps? Rely on Bayco for quality and long-lasting products.