Baytex ELECTRON 6m User manual

6m ELECTRON
Assembly Instructions
New Zealand
52 Newton Street,
PO Box 4370, Mount Maunganui
New Zealand
tel [phone]
fax [phone]
www.baytex.co.nz
Australia
tel [phone]
mob [phone]

1. Site Layout
lChoose a clear and level site.
lClearly mark the corners of the rectangle to
be covered by the tent.
lCheck that the diagonals are approximately
the same.
2. Position Corner Pegs
lSet out two wall poles on each corner square
with the rectangle.
lPosition each corner peg inside the 90°angle
described by the wall poles.
lUse your shoe as a measuring guide.
3. Drive Corner Pegs
Ensure each corner peg is fully driven as shown.
4. Layout remaining wall poles and drive
remaining tent pegs.
8. Stand all the remaining wall poles and
loosely tie off the guy ropes.
5. Spread roof out to cover marked rectangle. 6. Stand first wall pole, placing the bottom of
the pole on the corner mark.
7. Tension corner guys until corner pole is
more or less upright.

Don’t forget to tie the jump ropes!
9. Work on each corner to fully tension.
Eave lines must be tight and straight!
10. Assemble Centre Poles and install
centrepole spike into roof grommet.
11. Pull base of pole into an upright position.
Repeat for second Centre Pole.
6m ELECTRON
Roof Lacing Assembly
1. Line up the centre pole grommets. Make
sure the eyelets are on top and the lacing on
the bottom. Pull the outer sister clips together
and connect them.
2. Thread the centre sister clips through the
rain flap loops. Join the sister clips.

3. When correctly assembled the apex looks
like this.
4. Start from the top and lace down to the
eave line.
6. Pass the long lace through the two short
lacings.
LONG
SHORT SHORT
5. When you get to the bottom, the lacing will look
like this.
7. Tie off the long lacing as shown. 8. IMPORTANT. Turn to the underside of the roof
and make sure that the eaveweb sister clips are
joined.
aEfoeniL beWev
Sister Clips
are under here
9. The finished lacing join looks like this. 10. Pull the lacing line out flat.
Lightly tap down the rain flap velcro joins.