Baytex ALISPAN User manual

ALISPAN
Assembly Instructions
New Zealand
52 Newton Street,
PO Box 4370, Mount Maunganui
New Zealand
tel [phone]
fax [phone]
www.baytex.co.nz
Australia
tel [phone]
mob [phone]

Use the Spacer Bar to position the first two Base Plates.
Set out the width of the first Portal. Measure the Portal width from centre to centre.
Check the diagonals - they must be approximately equal
to each other. Assemble each Portal frame. Attach to Base Plates.
Attach the Gable Upright. Securely attach the Brace Cables.
Connect the Portal Base Stays on each side. Install the Gable Infill Fabric (optional). Lace the gable
sections together.
Set up the string line.
12
34
56
78
910
INSTALL SET UP
ASSEMBLE PORTALS

Attach the Push Pole and check that the Retaining Clip
and Cord are secure.
Lift the first Portal with everyone starting at the middle.
As the Portal is raised the crew should move outwards in
the direction of the arrows.
Hold the Portal securely in the not quite vertical position. Secure both Portal Brace Stays to the adjacent Base Plates.
Engage the Ridge Purlin hook end first. Raise the second Portal and rest on the Push Pole.
Use the Purlin Fork to engage the Ridge Purlin into the
second Portal.
Engage the roof and wall Brace Cables underneath the
Purlins.
IMPORTANT: All Brace Cables must be properly fitted
into a single bay as shown.
Lightly tighten all the Brace Cables.
RAISE PORTALS
FIT BACE CABLES
11 12
13 14
15 16
17 18
19 20

Remove the Brace Stays only when all the cable sare
securely fitted.
Continue to raise the remaining Portals by repeating the
process. A set of Brace Cables is only required on every
sixth Bay or as shown in the manufacturers layout.
At this point all Base Plates must be firmly fixed
down, ballasted or staked, with the required number
of stakes.
Engage one end of the Roof Panel into both Keder
grooves. Use the Pull Ropes to slide the roof panels into
position - pull both ropes together making sure that both
crew pull evenly. Install the Roof Tension Bars and tension evenly.
Install each Wall by sliding the Slugs into the bottom
track of the Eave Bar. Repeat for both sections of each Wall.
Slide the side of each Wall section into the outside Keder
Track of the Leg Extrusion.
Slide the Wall Bars in from the outside.
INSTALLING ROOF PANELS
21 22
23 24
25 26
27 28
29 30
INSTALLING WALLS