Winners Only BTP1002K User manual

Page 1 of 4
Allen Bolts
Flat Washers
Slat
WINNERS ONLYR
ASSEMBLY INSTRUCTIONS
HB Left Leg
Support Leg
STEP 1: Attach the Wood Stretcher (D) to both
Headboard Legs (A&B) using provided hardware
as shown on FIG.1
PROD.NO : BTG/BTH/BTP1002K
Thank you for purchasing this quality product . Please read instructions thoroughly before unpacking assembly parts
Caution: Sharp, exposed staple tips can cause injury. Therefore, for your protection, please remove any exposed staples used in
packing.
Please keep all hardware parts out of the reach of children.
1. We recommend that you should assemble this product with the assistance of another person; this will make assembly easier
and will help to prevent personal injury and to insure parts are not damaged during assembly process.
2. Before beginning,please check packing materials carefully for small parts that may have come loose inside the carton during
shipping.Do not discard any packing material until all parts have been located. If any parts are missing, please contact your
dealer for prompt replacement.
3. To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain residues and rough
surfaces and also check for staples or nails left after removing the packing materials .The manufacturer will not be held
responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts.During normal use everyday, screws, bolts , nuts and wooden plugs may loosen up.
They should be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and below mentioned components are attached to the furniture property
and kept tightened.
5. Please lay all parts and hardware on a non-abrasive surface such as a carpet and follow the assembly.
TIP: Store the Allen key and Wrench in assembly
in this product drawer or use masking or painter
tape to affix it to the underside of the
product.This will make it easier to find if you
want to periodically tighten bolts or disassemble
the product.

Page 2 of 4
WINNERS ONLYR
ASSEMBLY INSTRUCTIONS
FIG.2
FIG.3
STEP 3: Attach both Bed Rails (F) to the
Footboard (E) using the provided hardware as
shown on FIG.3
STEP 4: Attach both Bed Rails (F) to the
Headboard assembly (A,B,D&C) using the
provided hardware as shown on FIG.4
FIG.4
STEP 2: Attach the Headboard (C) to the Legs
assembly (A,B&D) using provided hardware as
shown on FIG.2
PROD.NO : BTG/BTH/BTP1002K

Page 3 of 4
WINNERS ONLYR
ASSEMBLY INSTRUCTIONS
STEP 5: Attach Support Legs (H) to Slats
(G)as shown on FIG.5
Assembly is now completed.
STEP 6: Attach Slats with Support
legs (G&H)to the Side Rail (F) using
the providedhardware as shown on
FIG.6
PROD.NO : BTG/BTH/BTP1002K