1 Recommendatons and Suggestons
A
The Instructions for Use
apply to several ver-
sions of this appliance.
Accordingly, you may find
descriptions of individual
features that do not apply
to your specific appliance.
1.1 Installaton
•The manufacturer wll not be held
lable for any damages resultng
from ncorrect or mproper
nstallaton.
•The mnmum safety dstance
between the cooker top and
the extractor hood s 650 mm
(some models can be nstalled
at a lower heght, please refer
to the paragraphs on workng
dmensons and nstallaton).
•Check that the mans voltage
corresponds to that ndcated on
the ratng plate fxed to the nsde
of the hood.
•For Class I applances, check
that the domestc power supply
guarantees adequate earthng.
•Connect the extractor to the
exhaust flue through a ppe of
mnmum dameter 120 mm. The
route of the flue must be as short
as possble.
•Do not connect the extractor
hood to exhaust ducts carryng
combuston fumes (bolers,
freplaces, etc.).
•If the extractor s used n
conjuncton wth non-electrcal
applances (e.g. gas burnng
applances), a suffcent degree
of aeraton must be guaranteed
n the room n order to prevent
the backflow of exhaust gas. The
ktchen must have an openng
communcatng drectly wth the
open ar n order to guarantee
the entry of clean ar. When the
cooker hood s used n conjuncton
wth applances suppled wth
energy other than electrc, the
negatve pressure n the room
must not exceed 0,04 mbar to
prevent fumes beng drawn back
nto the room by the cooker hood.
•In the event of damage to the
power cable, t must be replaced
by the manufacturer or by the
techncal servce department, n
order to prevent any rsks.
