Beliani OS1500 User manual

Instruction Manual
Model: OS1500
Please keep this instruction for future reference.
The picture is for reference only. Please adhere to the original products.

Warning
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE,
We cannot be liable for any damages caused by failure to observe these instructions.
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY-The infrared heater is designed for safe operation. Nevertheless, installation, maintenance and
operation of the heater can be dangerous. Observing the following procedures will reduce the risk of fire, electric
shock, injury to persons and keep installation time to a minimums. Save these instructions for future used.
1. Read all instruction before using this heater.
2. Remove the unit from it’s packaging and check to make sure it is in good condition before using.
3. Do not let children play with parts of package (such as plastic bags).
4. Check the household voltage to ensure it matches the heater’s rated specification.
5. Check the power cord and plug carefully before used, to make sure that they are not damaged.
6. Before unplugging the power cord, be sure to turn off the power, when energizing the unit, be sure your hands
are dry to prevent from electric shock.
7. Do not use flammable objects near or point the heater like furniture, pillows. bedding, paper, clothes and
curtains at least 3 feet (1meter) from the front of the heater and keep them always the sides and rear.
8. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
9. To protect against electric shock, do not immerse cord or plug in water or any other liquid.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening , as this may cause an electric
shock, fire or damage to the heater.
11. Always unplug the heater when not in use.
12. Do not allow cord to overhang the counter top where it can be easily pulled by children.
13. Do not put fingers or foreign objects into the grill while in operation.
14.This heater is not intended for use in bathrooms, laundry and similar indoor locations, never located heater
where it may fall into a bathtub or other water container.
15.No liability can be accepted for any damage caused by non compliance with these instructions or any other
improper use or mishandling.
16. This appliance is not intended for use by persons (including children) with reduces physical, sensory or mental
capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety. Children and vulnerable people should be
supervised to ensure they do not play with the appliance.

17. If the supply cord is damaged in any way, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
18. To prevent overheating of this appliance, keep the air inlets and outlets clean and free of anything that may
cause blockage. Check all inlets and outlets from time to time to ensure it is clear of any dirt or dust accumulation.
DO NOT COVER.
19. Parts of the heater may exceed 200℃, contact with the heating tube, reflector, or metal parts near the heating
tube, may cause severe BURNS . To avoid burns, do not let bare skin touch hot surface
20. NEVER place hands under the heating elements. ALWAYS allow heating element to cool at least 10 minutes
before touching the heating tube or adjacent parts.
21. This product contains recyclable materials. Do not dispose this product as unsorted municipal waste. Please
contact your local municipality for the nearest collection point.
22. Infrared Heater is for household use only.
23. This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
24. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
25. The heater must be installed at least 1.8 m above the floor.
26. The heater must not be located immediately below a socket-outlet.
Introduction
The infrared heaters produce instant and comfortable heat like the sun.
These robust and weatherproof heaters are designed for domestic heating applications within indoor and outdoor
areas.
INSTALLATION
Important: Ensure that the supply cables is well mounted and that it does not come into contact with reflector of
the heater or that does not trail into heated area.
Model:
OS1500
Voltage:
220V-240V 50Hz-60Hz
Power:
1500W
Net Weight:
1.7kg
Size:
￠42.5*42.5*18cm
Chain length
50cm

1.This heater should be installed by a competent person, i.e. a qualified electrician.
2.Always disconnected the heater from the electricity supply and allow it to cool before installation.
3.This heater can be heat directly.
4.The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically.
5.Keep the supply cord away from the body of the heater which will get hot during use.
6.Do not install the heater on an inflammable surface.
7.Observe the minimum safe distance between the heater body and the inflammable surfaces when mounted.
8.If the heater is to be used outside, a weatherproof outlet is recommended.
9.Before drilling ensure that there are no wires or water pipes in the area where the heater is to be installed.
10.The heater must be installed on the mounting chain provided.
11.Fasten the chain securely to the mounting surface.
12.Fasten the heater securely on the chain.
INSTALLATION AND ASSEMBLY
Please check all the items against the parts list after opening the box. Only all the items are complete, the
installation could be followed.
2、Requirements of Installation:
Do not allow children to install the equipment.
Keep 35cm distance form heater to ceiling.
Keep at least 80cm distance between heater and surrounding.
Keep at least 180cm height form heater to ground.

Function and operation :
Plug-in, press switch ON, heater working
Plug-in, press switch OFF, heater stop working
Off-plug, heater power off
Notice
1.The power supplied to this unit must comply with electrical requirement on itslabel.
Damage or fire may result if the incorrect power used.
2.Do not use the heater in somewhere with flammable objects, gas, dust.
3.In order to avoid scalding, forbid to touch the heater when it works.
4.Forbid to put anything on product surface when it is working.
5.To avoid possible electric shocks, do not place the heater in bathrooms or similar indoor location.
6.In order to avoid fire, do not use the heater with automatic electrified sequencer, timer and other devices.
7.Do not allow children or disabilities to use the heater alone.
8.Turn off all switches and unplug the heater if an emergency situation occurs.
9.Please contact with seller if it does not work properly. Do not try to repair the heater by yourself.

10.Please contact the seller if you find other problems not covered in this operation manual.
11.The heater must not be located immediately below a socket-outlet
CLEANING AND MAINTENANCE
Always turn off and unplug the heater before cleaning.
To clean the heater use a damp cloth and make sure to dry excess water oncecleaned.
ATTENTION Do not put the heater directly into any container with water in it.
TROUBLE SHOOTING
1.If the heater does not emit heat after turning on, please check the power cord whether plugged into electric
socket properly.
2.In first use, it is normal if the heater appears small amount of smoke and some smell because of protective-
oil evaporate
CLEANING AND MAINTENANCE
Regular and careful cleaning helps your infrared heater operate efficiently for many trouble
free years. To clean your heater follow steps below:
1. Unplug the power cord for your safety before cleaning your appliance.
2. Make sure the heater is cool before continuing.
3. To keep the heater clean, the outer shell maybe cleaned with a soft, damp cloth. You may
use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. (CAUTION:
DO NOT let liquids enter the heater).
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to
clean the heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water
6. Wait until the heater is completely dry before use.
Storage: Store the heater in a cool, dry location when not in use to prevent dust and dirt
build up. Use packaging carton to store.
ATTENTION:
1. Always disconnect the heater from the electricity supply and allow it to cool before
attempting to work on it.
2. If the heater has collected dust or dirt inside the unit or around the heating element,
have to unit cleaned by a qualified service agent. Do not operate the heater in this
condition.
3. The only maintenance required is cleaning of the external surfaces of the heater.
4. Do not touch the heating element with bare fingers, as residue from your hand could
affect the life of the lamp. If it is accidentally touched, remove the finger marks with a
soft cloth moistened with mentholated spirit or alcohol.
5. Do not attempt to repair or adjust any electrical or mechanical functions on this heater.
6. The heater contains no user serviceable parts. Should the product suffer
damage or breakdown, it must be returned to the manufacturer or its service
agent.

7. Damaged supply cords to be replaced by the manufacturer, service agent or similarly
qualified person in order to avoid hazard.
RECYCLING
At the end of the electrical products useful life it should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority or retailer for
recycling advice in your country.
Powered by TCPDF (www.tcpdf.org)