BigTimeClocks 280 User manual

!
!1
MODEL #280
12” NUMERALS WATERPROOF
GPS WALL CLOCK
2018 USER’S MANUAL
BIGTIMECLOCKS
•Connect the power cable on bottom of the clock and screw in tightly. Press the power on/off
switch. Remote control uses A23 12 volt battery
•Press A once and 00:00 is flashing, then press B to choose either 12/24hour, press C to save
•Press A twice, to change the Hour, use B and C as UP and DOWN key
•Press A three times to change Minute, also use B and C to increase or decrease . Press C to
save.
•The clock has internal GPS. Set the clock initially to the correct time. Then select time zone and
after a short period the clock will adjust to accurate time. When placed outdoors the clock should
have no problem receiving the satellite GPS signal. However if using indoors place near a window
and experiment in different places if you do not receive the GPS signal to automatically adjust to
the correct time.
1-702 726-9030
[email protected]
www.bigtimeclocks.biz
Press A four times, and it shows “on:20”,
Press B to turn GPS ON .You can choose “On” or “Off”
When "On:20 is flashing, use Button B to choose different time zone and press C to save as
follows:
US East ! ! On:20
US Central ! ! On:19
US Mountain! ! On:18
US West ! ! On:17
2. SETTING GPS
1. OVERVIEW
®

!2
US Alaska ! ! On:16
US Hawaii ! ! On:14
You can chose other time zones. Scroll through using B. After selection press C to save
On the bottom of the clock adjacent to the power on/off switch there are three buttons
corresponding to A B and C. Use these buttons in an emergency if you have lost the remote
and need to change a setting