Bionaire BOH1503 User manual

INSTALLATION OF A PLUG – Applicable to
U.K. and Ireland.
NOTE: If you are in any doubt about wiring
and the installation of the plug. Please contact a
qualified electrician.
NOTE: If a 13A 3-pin plug is fitted, it must
be an ASTA approved plug, conforming to the
BS1363 standard. Replacement 13 amp fuse
must also be BSI or ASTA approved.
The wires in this mains lead are coloured as such:
GREEN & YELLOW - Earth
BROWN - Live
BLUE - Neutral
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug.
Please proceed as follows:
• The wire which is coloured GREEN & YELLOW
must be connected to the terminal which is
marked with the letter E ( ) or is coloured
GREEN, or GREEN &YELLOW.
• The BROWN coloured wire must be connected
to the pin terminal, which is marked with the
letter L (Live) or is coloured RED.
• The BLUE coloured wire must be connected
to the pin terminal which is marked with the
letter N (Neutral) or is coloured BLACK.
• DO NOT CONNECT either of these wires
to the earth terminal in the plug. The earth
terminal is marked with the letter E ( ) or is
coloured GREEN, or GREEN & YELLOW.
GUARANTEE
Please keep your receipt as this will be required
for any claims under this guarantee.
This appliance is guaranteed for 5 years after
your purchase as described in this document.
During this guaranteed period, if in the unlikely
event the appliance no longer functions due to
a design or manufacturing fault, please take
it back to the place of purchase, with your till
receipt and a copy of this guarantee.
The rights and benefits under this guarantee
are additional to your statutory rights, which are
not affected by this guarantee. Only Holmes
Products (Europe) Ltd. (“Holmes”) has the right
to change these terms.
Holmes undertakes within the guarantee period
to repair or replace the appliance, or any part of
appliance found to be not working properly free
of charge provided that:
• you promptly notify the place of purchase
or Holmes of the problem; and
• the appliance has not been altered
in any way or subjected to damage,
misuse, abuse, repair or alteration by a
person other than a person authorised by
Holmes.
Faults that occur through, improper use,
damage, abuse, use with incorrect voltage,
acts of nature, events beyond the control of
Holmes, repair or alteration by a person other
than a person authorised by Holmes or failure
to follow instructions for use are not covered
by this guarantee. Additionally, normal wear
and tear, including, but not limited to, minor
discoloration and scratches are not covered by
this guarantee.
The rights under this guarantee shall only apply
to the original purchaser and shall not extend to
commercial or communal use.
If your appliance includes a country-specific
guarantee or warranty insert please refer to
the terms and conditions of such guarantee
or warranty in place of this guarantee or
contact your local authorized dealer for more
information.
This marking indicates that this product
should not be disposed with other household
wastes and should be disposed separately
throughout the EU. To prevent possible harm
to the environment or human
health from uncontrolled waste
disposal due to the presence of
hazardous substances within the
product, recycle it responsibly to
promote the sustainable reuse
of materials and resources. To
return your used device, please
use the return and collection systems available
to you or contact the retailer where the product
was purchased. They can take this product for
environmentally safe recycling.
Holmes Products (Europe) Limited
1 Francis Grove
London
SW19 4DT
UK
4
Holmes Products (Europe) Ltd.
1 Francis Grove
London SW19 4DT
England
Fax: [phone]
Email: [email protected]
UK - Filter Sales Order Line - 0870 759 9000
Website address: www.bionaire.com
UK - Free phone Customer Service Helpline – 0800 052 3615
© 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved.
Distributed by Holmes Products (Europe) Ltd., 1 Francis Grove, London SW19 4DT, United Kingdom. Printed in PRC
© 2010 Sunbeam Products, Inc. faisant affaires sous le nom de Jarden Consumer Solutions. Tous droits réservés.
Distribué par Holmes Products (Europe) Ltd., 1 Francis Grove, London SW19 4DT, United Kingdom. Imprimé en RPC
P/N: 138183
INSTRUCTION MANUAL
OIL FILLED
RADIATORS
MODELS# BOH1503, BOH2003,
BOH2003B, BOH2503
SPR-060210
pure indoor living

PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety
precautions should always be taken including
the following:
1. Before connecting the heater, check that
the voltage indicated on the rating plate
corresponds to the main voltage in your
home/office.
2. WARNING: In order to avoid overheating, do
not cover the heater ( ) Reference to
product.
3. DO NOT position the heater directly under
a power socket.
4. DO NOT use this heater in the immediate
surroundings of a bath, a shower or a
swimming pool.
5. If the supply cord or plug is damaged, it must
be replaced by the manufacturer or its service
agent or similarly qualified person in order to
avoid hazard. The heater contains no user
serviceable parts. Should the product suffer
damage or breakdown, it must be returned to
the manufacturer or their service agent.
6. Under the environment with electrical fast
transient, the product may malfunction.
7. DO NOT use this heater with a
programmer, timer or any other device
that switches the heater on automatically,
since a fire risk exist s if the heater is
covered or positioned incorrectly.
8. Only touch the heater with dry hands.
9. DO NOT use this heater outdoors.
10. DO NOT position where it can be touched by
children, especially the very young.
11.Allow a safe area around the heater away
from furniture or other objects; at least 50 cm
from the top and sides and 200 cm at the
front. The heater is to be placed at least 3m
from water source.
12. DO NOT use this heater when it is lying on
its side.
13. DO NOT use the heater in rooms with
explosive gas (e.g. petrol) or while using,
oxygen, inflammable glue or solvent (e.g.
when gluing or varnishing parquet floors,
PVC etc.)
14. DO NOT insert any objects into the heater.
15. Keep the mains cord at a safe distance from
the main body of the heater.
16. If overheating should occur, the built-in
overheating safety device will switch off
the heater.
17. DO NOT place the cord under a rug.
18. The heater cannot be used adjacent to
curtains or combustible material. Curtains or
combustible material may be burned if the
heater was installed incorrectly.
19.This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
20. This heater is filled with a precise quantity
of special oil. Repairs requiring opening of
the oil container are only to be made by
the manufacturer or his service agent who
should be contacted if there is an oil leak;
21 When scrapping the heater, follow the
regulations concerning the disposal of oil.
DESCRIPTIONS (See Fig. 1, 2 & 3)
A. Heated Fins
B. Vents
C. Pull down handle
D. Front Panel
E. Cord Storage.
F. Power cord
G. Front castor assembly
H. Thermostat Knob
I. Power light
J. Control Knob
K. Front wing nut
L. Castor
M. Rear Castor assembly
N. Rear wing nut
0. U bolt
Technical Specifications
BOH1503
Wattage: 1500W
BOH2003/B
Wattage: 2000W
BOH2503
Wattage: 2500W
ASSEMBLY INSTRUCTIONS (See Fig. 3)
Please make sure the heater has not been
plugged into any electricity outlet.
Carefully remove heater from box. Some
accessories are packed internally. Please make
sure you have all of the following accessories
prior to throwing away packaging.
2 Castor assemblies with four castors (M, G & L),
and 2 U Bolts with wing nuts (O, K, N).
2
U.K. and IRELAND
3
Note: This unit is for FLOOR USE ONLY.
1. Turn the heater upside down and you will see
2 U bolt’s (O) with wing nuts over the first and
last joint of the heater.
2. Unscrew the wing nuts (N & K) from the
U-bolts (O).
3. Start with the front of the unit and place one
hole of the front castor assembly (G) to the L
shape of the U-bolt (O) and the other hole of
the castor assembly into the other end of the
U-bolt, then screw on the wing nut (K).
4. Repeat step 3 for the rear castor assembly,
using wing nut (N) instead of wing nut (K) and
rear castor assemblies (M).
5. BOH1503 ONLY. Use your hand to press the
four casters (L) onto the four axis of the two foot
plates until you hear them click into place. Use
your hand to turn the castors and if the move
smoothly they have been installed properly.
6. After installation of the front and rear castor
assemblies and the castors turn the heater
the right way up: the heater is now ready
for use.
NOTE: BOH1503 ONLY. Make sure when
assembling the castor assemblies and castors
that they are pointing outwards for maximum
stability.
OPERATING INSTRUCTIONS
(See Fig. 1 & 2)
1. Set the unit to the OFF (O) position.
2. Plug in heater.
3. Set the Thermostat Knob (H) all the way to
the right.
4. Turn the Control Knob (J) to desired level of heat.
BOH1503: 1 = 700W, 2= 800W, 3= 1500W
BOH2003/B: 1= 900W, 2= 1100W, 3= 2000W
BOH2503: 1= 1200W, 2= 1300W, 3= 2500W
NOTE: When the heater is in use, it is normal
that the heater cycles ON and OFF, this is to
maintain your desired temperature.
After using the heater, turn the Control Knob (J)
to “0” position, turn the Thermostat Knob (H)
to lowest temperature position and unplug the
heater from the socket.
SETTING THE THERMOSTAT
1. Set the Thermostat control all the way to max.
2. When the desired temperature/comfort level
is reached, turn the thermostat control
anti-clockwise to a lower position or until the
heater stops operating.
3. The control will now automatically maintain
the pre-set temperature level by turning the
heater ON and OFF.
NOTE: The Power light will remain lit during
operation.
NOTE: It is normal for the heater to cycle ON
and OFF as it maintains the preset temperature.
FROST GUARD INSTRUCTION
Plug the heater in, then select the highest heat
setting (3), then turn thermostat knob to the
lowest temperature position () the temperature
will be maintained at 5° C, thus the heater will
be in the off status unless the room temperature
is lower than 5° C. If the room temperature is
lower than 5° C, the heater will automatically start
working and will keep turning on & off all the time,
maintaining its ambient temperature of 5° C.
NOTE: Unit must be unplugged for it to be fully
off.
TIP OVER PROTECTION
When the unit is accidentally knocked over, or
tilts on one side at more than a 45° angle; it
will instantly shut off. To reset, simply place the
heater in an upright position.
TRANSPORTING THE UNIT
Locate the pull down handle (C) above the control
panel. Pull down to release and then grasp the
handle. Pull the unit using the handle ensuring that
all castors are in contact with the floor.
NOTE: Do not use handle to lift the product .
STORAGE TIPS
If the heater is not required for long periods,
for example during the summer, it should be
stored at room temperature; in a dry place and
preferably covered to prevent the accumulation
of dust and dirt.
FITTING A REPLACEMENT PLUG FOR
U.K. AND IRELAND ONLY.
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by
a plug of the correct type. For correct type and
correct installation please refer to “Installation of
a plug” below.
BOH1503/2003/2503
Fig. 1
Fig. 2
A
B
C
E
L
H
I
J
1
3
2
1
3
2
Fig. 3
D
L
G
K
M
N
O
O
G
F