ESC505
Charging the battery
• Make sure that the electrical outlet is dry.
• Open the battery charging socket cap on the vertical bar beneath the display.
• Plug the adapter plug into the power source (110 V ~ 240 V, 50 Hz ~ 60 Hz), make sure the green
charging lamp is lit, insert the other adapter plug into the scooter’s charging socket.
• When the red LED on the power supply lights up, the battery is charging correctly, otherwise check
all cable connections.
• When the red light turns green, the battery is fully charged. Disconnect the power supply from the
power source. Long-lasting charging can shorten battery life.
• Follow the instructions for charging the battery, otherwise it will damage the battery and shorten
its service life.
• The time to charge the scooter’s battery is about 2 hours. The manufacturer cannot guarantee the
same charging time and operation of the battery due to its wear.
• Ensure clean and dry conditions when charging the battery.
• Do not charge the battery when the power outlet is wet.
First run
Preparation
• Select the desired location. This place can be inside or outside, it must have an area of 10 x 10 meters
(about 100 square meters). The place should be flat, neither wet nor slippery, without obstacles,
without vehicles, children, pets or any other things that could distract your attention.
• Read this manual carefully, if you have the opportunity to do so, for advice from a person who is
more experienced in safe driving.
• Wear helmet and protectors to avoid possible injuries. Move the scooter to the center of the area
where you will be moving and familiarize yourself with the area.
Start-up
• Switch on the scooter with the on/off button located underneath the display on the left. Press the
"Mode" button to select the speed mode from three "Slow/Mid/Fast" options. It is recommended to
use the "Slow" mode for the first ride.
• The lever on the right-hand side of the handlebar is used to increase the speed, the lever on the left-
hand side of the handlebar is used to brake. By applying pressure to the rear wheel mudguard, an
additional foot brake is achieved.
• The button next to the battery charging socket is used to switch on the LED front lights.
• The platform should be horizontal when the scooter is started. Do not stand on the platform before
turning on the scooter; this is valid especially for beginners.
• Do not climb on the scooter before turning on the power or if the scooter is in a bad technical
condition. This can cause imbalances and injuries.
• Do not board a scooter until the diagnostic process is complete after it has been started. Stop if you
hear disturbing noises or feel vibrations from your scooter even if the display is working properly.
Cleaning and storage
• Clean the scooter after each ride.
• If the rubber surfaces are difficult to clean, use a toothbrush and toothpaste and clean them with a
soft cloth. This method can also remove small scratches.
• Store the scooter indoors, in a cool and dry place. Do not expose the scooter to prolonged sunlight.
When cleaning, the battery charging receptacle must be tightly closed, otherwise you may be
electrocuted and the scooter may be seriously damaged. Do not wash your scooter under a high
pressure water jet or immerse it in water - this may cause irreparable damage to the unit.
6
