BLINDS2GO EasiFIT User manual

Installation Guide
EasiFIT Pleated Blinds
Cord attachments
Cord attachments
Brackets
Brackets
Allocate the brackets so that those with the ‘winged’ area to
the right are used for the left hand side of the blind, and
those with the winged area to the left are used for the right
hand side of the blind.
Take care if using scissors or a knife to open the
internal wrapping - make sure you do not cut the
wrapping on the same side that the cords are
stored.
Unpacking the blind and fitting the brackets
Place the transparent circular pads
onto the back of each bracket.
Then, clip the cord attachments
onto the brackets.

Fitting the blind
Fine-tuning the tension
Installation Guide
EasiFIT Pleated Blinds
Glass
Window Frame
Angled Bead
Rubber Seal
Bracket
The bracket should be pushed right
under the frame, so that it’s flush with
the bead (the edge of the glass area).
Click the brackets into the window to complete the
installation.
NB: The bracket fits under the rubber or Mastik seal
so that it sits flush to the glass area.
If the seal is quite stiff, apply a small amount of
washing-up liquid to the area that the brackets will
be fitted to ease the installation.
Tighter Looser
The tension on the blind should be correct for your window size as soon as the blind is fitted. However, if you find that the blind is a
little loose and slips down or is stiff to operate, you may want to adjust the tension.
This can be done without taking the blind down, just move the knot on the cord along to the adjacent slot on the cord attachment.
Move the knot to the outer slot (away from the centre of the window) to tighten the tension, or to the inner slot (towards the centre of
the window) to loosen the tension.
While all four brackets allow for the tension to be altered, it’s rare that all four would need adjusting. Adjust the bottom two knots first
(always do both to keep the tension even) then test the blind, the tension should now be corrected. Only alter the position on the top
brackets if further adjustment is required.