BLINDS2GO PerfectFIT User manual

Installation Guide
PerfectFIT Roller Blinds
Assembling the frame
Unpack the blind and frame (the side and bottom frames are packed separately in the same box), then lay out all the parts and push
the control chain to one side so it doesn’t get tangled.
Attach the side frames to the top
and bottom by inserting the pegs on
each corner section into their
corresponding channels in the
frames.
Before you slot the frames together,
clip the corner cover pieces onto the
corner joints so that they’re firmly
attached.
Guide the side runners on the ends of
the blind’s bottom bar into the
channels on the inside of the side
frames.

Installation Guide
PerfectFIT Roller Blinds
Push the frame towards the window until the oval slots lock
onto the prongs of each of the brackets. The installation of the
blind is now complete.
Line the assembled blind up with the brackets so that the centre prong of the bracket is aligned with the oval slot on the frame.
Ensure that the frame is sitting on the inside edge of each of the brackets (between the bracket and the glass).
Installing the blind
Installing the brackets
Securing the operating chain
Locate the correct position for the brackets by
holding a credit card or store card vertically in
the corner of the glass - the bracket will sit in
line with the edge of the card.
Keeping the chain taut, press the chain runner firmly
against front of the side frame to stick it in place.
Peel the sticky pad (packed with the brackets) from its plastic sheet and stick it
to the back of the chain runner. Peel the cover from the back of the sticky pad.