SurfaceView Roller Blind User manual

How to install
Roller
Blind
Installing your blind is easy. We supply all of the
necessary brackets and ixings to install into your wall
or window recess.
If you have any questions about installation,
please contact us on
[phone] or email info@surfaceview.
co.uk for further information and advice.
www.surfaceview.co.uk/support/blind
www.surfaceview.co.uk/support/blind/ilm
Supplied
Roller blind system
Brackets
Fixing screws
Control Chain Safety
Clip
What you’ll need
Tape Measure
Spirit Level
Soft Pencil
Drill
1

Brackets
Positions illustrated are for a blind with
the control chain on the right. For a
blind with the control chain on the left
the bracket should be on the opposite
ends. Brackets can be ixed to any lat
surface behind or above our blinds.
First mark the location of the brackets
and use a spirit level to check they are
level. Also check that the rolled fabric
will not touch any surface. Use the
appropriate screws to ix the bracket to
your wall.
Blinds
Hold the blind to the brackets with
the fabric hanging in front of the blind
system. Fit the spring plunger into
its bracket. Push the blind into this
bracket, depressing the plunger. With
the locating hook pointing downwards,
place the hook into the vertical part of
the ‘+’ shaped bracket. Allow the hook
to drop downwards so that it locks into
place in the bracket.
Each roller blind is supplied with a
control chain safety clip which we
recommend to be installed with each
blind.
1.
4.
2.
5.
3.
Roller
Blind
2
A
D
B
E
C