BOLD SX Series User manual

BOLD SMART LOCK
SX SERIES
Installation Manual
1. Use the Allen key supplied to loosen the
Allen bolt of the outside knob.
2. Remove the outside knob from the lock.
3. Use a screwdriver to loosen the locking pin
of the old cylinder lock.
4. Remove the old cylinder lock.
Optional: The interior is locked so that it cannot
be unwantedly removed.
Tighten the locking screw on the insidewith the
supplied Allen key.
Check with the old cylinder lock that the length
of the central hole to the inside and outside of
the Bold cylinder is the same. Extend cylinder if
necessary.

5. Insert the lock into the cylinder opening.
6. Use a screwdriver to tighten the cylinder
locking bolt of the lock.
7. Do not over-tighten the cylinder locking
bolt. This may adversely aect the function
of the lock.
For a door element with anti-core pulling
fittings there is a maximum overrun of the
cylinder of 1.5 mm. Use one of the supplied
adapters to adjust the length of the lock.
Alwaysconsultthemanualoftheanti-corrosion
fitting before fitting the lock.
For a door element with a normal fitting, a
maximum overrun of the cylinder of 3 mm
applies. Use one of the supplied adapters to
adjust the length of the lock.
8. Put the outside button back on the lock.
9. Use the included inbus key to secure the
lock’s inbus bolt.
BOLD SMART LOCK
SX SERIES

Push the two pins inwards to remove the inside.
Open the battery compartment
Remove the inside of the housing of the inside
knob
How to replace the battery
Remove the battery from the battery
compartment
Insert a new battery and put the inside back
into the housing of the inside knob. Reinstall
the lock in your door.
BOLD SMART LOCK
SX SERIES