Bolide SVR9000s Series User manual
DVR REMOTE ACCESS SETUP GUIDE
START HERE
EASY SETUP STEP 1 - 2 - 3
Connection Diagram
IMPORTANT:
Setting up remote
access, DSL/Cable
internet service, a
router and a PC are
required. Some ISPs
may block incoming trafc,
please consult with your ISP when you have
any connection difculties.
!
Need More Help?
For information about features, please refer to the user manual for example settings and denitions. Additional product information can also
be found in the Product Manual on the CD. Please feel free to give us a call or simply log on to http://www.bolideco.com for more information
and support.
Bolide Technology Group
is a ISO 9001:2008 Certied Corporation
12
3
Connect cameras to your DVR and plug in the net-
work cable from DVR to Router.
Once you have the connection ready, go to
main menu on the DVR > Network
Choose DHCP > APPLY > EXIT
Then reboot your DVR.
After the DVR is rebooted, you will receive an
IP address from the Router.
For example here: 192.168.001.100
To nd out your network’s IP, simply go to
http://www.whatismyip.com
After setting up the IP in the DVR, go to your PC and log in to your
router (Router login information can be found in your router’s user
manual). Once you have logged into your router, go under port for-
warding/rewall settings open the communication Port 80, 9000 and
point it to your DVR IP address, for example 192.168.1.100
*If you did not get an IP
from router, simply repeat
Step 2 again and check
your network cable.
*If you encounter IE Active X error, please go
to internet options > enable all Active X control
under security settings. Please also make sure
your computer is set to the same network mask.
Internet / WAN
LAN / Local Area Network
Router
SVR9000s Series
Other Bolide DVR manuals
