Bonsaii C204-C User manual

Customer Service: customer-car[email protected]
Call Service: 1-844-728-6917
6 Sheets Cross Cut
C204-C Paper Shredder
Ins

1
Dear customer,
Thank you for purchasing this quality product. Please carefully read through this
manual before first using the device, pa en o the safety warnings.
You can find informa o contact support at the end of these opera
ins
Safety prec
Warning:
1. K wellery , hair , or other small
items away from the feed opening to prevent injury.
2. K edder is not in use for prolong
3. Do not place hands or fingers into the shredder throat as serious injury could
result.
4. Always turn off or unplug the shredder prior to moving, cleaning or emptying the
wastebasket.
5. Empty wastebasket frequently.
6. The document shredder must alway ated and disconnected from the
electrical line prior to moving, tr vice and prior to
emptying the waste basket.
7. Please do not leave the document shredder una ended e.g. in the event children
or pets are nearby.
8. It only allows to shred papers and staples .
9. The device may not be operated with a damaged power cord.
10.For indoor use only.
11.This machine is no toy. Keep it away from children and pets.
12.Please do not spray any flammable gas or oil onto this shredder, it may cause fire.
13.Please read the manual before opera
4x45mm
6
14.Sharp edges,Do not touch .

2
1. Place the shredder securely on top of the waste basket.Be sure not to allow your
fingers to get between the basket and the shredder as you are placing the shredder in
place.
2. Plug the power cord into any standard 120 volt AC outlet.
Setup:
Opera the shredder:
The Main Switch and POWER /OVERHEAT/OVERLOAD LED are located on the top of the
shredder. The Main Switch has three (3) se
1. AUTO:
When “AUTO” is selected, the POWER /OVERHEAT/OVERLOAD LED will be on, the
shredding process is started automa to the feed opening. The
shredder will stop automa ally when the paper has completed its travel through the
feed opening.
2.REV:
“REV” is used to assist in the removal of a paper jam, which reverses the shredder
process prior to a completed cy ers.
15.This equipment is not intended for use by children.Avoid touching the media feed
opening with the hands,clothing or hair. Unplug this equipment when not in use for
an ext
16.Shred width of 5/32 × 1-25/32 inches .
17.6-Sheet capacity .
4x45mm
6
1. Toggle switch(AUTO/OFF/REV)
2. Shredded paper entrance
3. Power indicator
4. Handle
5. Transparent window
6. Paper bucket
Opera ins
13
24
5
6
18.Remove all paper clips from paper before shredding.

3
Overloading:
Overhea
If you insert too much paper top. In this event, set the switch to
“REV” in order to remove the paper. Reduce the number of sheets and then try again.
The motor may overheat if you exceed the maximum period of con a
stated. The shredder will stop automa ally and the indicator light “Overheat” is on.
The device changes into Standby-Mode to cool down and can be used again a er the
indicator is off.
Removal of le over paper:
Turning off:
Set the switch to “OFF” and unplug the power socket. Remove the shredding a achment
and then you will able to take out any scraps of paper that have become caught in the
e very sharp so you should proceed with extra c
the shredder a achment back on top, plug in the power socket and turn the device on
again. You will then be able to start using the device again.
Set the switch to “OFF” in order to turn the device off en ely.
Both abnormal opera y r a oma or overheat/
overload prot ermi nates the power to the unit. If this occurs, you should:
1.Unplug the power cord from the AC outlet to allow shredder to cool down. Tear or cut
off any excess paper from the top of the shredder.
2.Plug the power cord back into the AC outlet and place the Switch in REV. Pull the
r ers・Place the Switch back to the Aut
necessary clear the feed opening of any remaining shredded pieces of paper, Keep
fingers away from feed opening to avoid harm.
3.With the Main Switch in the AUT eed opening clear, you are now
ready to resume normal shredding .
C204-C will shred six (6) sheets of A4 size 75g/m² paper, and will accept paper width up
to 220mm. When shredding small material like envelopes or receipts, insert them
through the middle of the feed opening.
Shredder capacity:
3.OFF:
“OFF” is used to terminate the power to the shredder. The mode is recommended when
emptying the wastebasket or when the shredder is not in use for a proIonged period of

4
Trouble Shooting
Malfunction Reason Solution
Stop Working
Jam
Keep Running
Loud Noise
The power plug is not connected
to the power supply.
The machine head is not aligned
with the jam position of the paper
waste bucket
Power supply voltage is too low
or no power supply
The machine enters the protection
mode due to overheating after
continuous working for a long time.
The thickness of paper is too thin
Overloading is not in contact
Paper jam beyond the rated
shredded paper
Paper dust and other foreign
objects cover the sensor.
The shredder is placed on a
unsuitable place.
Plug in again correctly
Lift the head of the machine and
align it with the paper scrap bucket.
Turn off the power switch and wait
for the voltage to return to be normal
before operating the machine
Wait for the machine to
cool down naturally
Add an opaque paper or fold the
transparent paper multiple times
Reduce paper quantity to an
acceptable amount and refeed into
the paper entry
Toggle the switch to the "reverse"
position to eject excess paper
Clean the dust or foreign objects.
Change location
Damage of power cable
Please replace the power cable with
the same parameters. If not, please
contact customer service.
If the above operation can not solve your problem, please contact our customer service
team via email [email protected].
The basket is full Dump confetti

5
Technical specifica
e:
Security Level:
Noise Level:
Shr
Net Weight:
Trash Bin:
Dimension(inches):
Power Supply:
Max. 6 sheets
5/32 x 1-25/32 inches
1.8m/min(6 sheets)
P-3
<70 dB
paper/staple
7.5 LBS
3.4 Gallons
11.9 x 7.4 x 15.2 inches
120V AC, 60Hz, 1.2A
WARRANTY SERVICE
The warranty for this appliance is for 12 months from the date of purchase from an
authorized dealer. The appliance has been manufactured with care and me
examined before delivery. Please retain your receipt as proof of purchase. In the case of
a warranty claim, please make contact with our Customer Service.
The warranty covers only claims for material and manufacturing defects, but not
for transport demage, wearing parts or for damage to fragile components, e. ons
or ba eries.
This product is for domes tended for commercial use.
The warranty is void in the case of abusive and improper handling, use of force and
internal tampering not carried out by our autorised service branch.
Your statutory rights are not restricted in any way by this warranty. The warranty period
is not extended by repairs made under the warranty. This applies also to replaced and
repaired parts.
Delivery:
Shredder
Ins manual
Should the ins above not help resolve the issue,then please contact our
product support:
Email Service: customer[email protected]
Call Service: 1-844-728-6917
A en
Never shred envelopes( any window, insulated or with glued flaps) adhesive materials
(labels, decals/s ers or glued paper), newsprint, transparencies, laminated documents,
con orms, cardboard, or hard and plas terials.

5

6
Made in Vietnam