Bonsaii DocShred C209-D User manual

C209-D
10 Sheets Cross Cut

4

The Main Switch and POWER LED, OVERLOAD (OVERHEAT) LED are located on the top of
the POWER LED will be on, the shredding process is started
the shredder may occur overheat, and the OVERLOAD (OVERHEAT) Indicator will be red e.g.
More than 4 minutes for computer paper without stopping.
ten (10) sheets at one pass, or if the paper is not fed squarely into the feed opening, and the
OVERLOAD (OVERHEAT) Indicator will be flashing.
C209-D ten(10)
C209-D
OVERLOAD (OVERHEAT)
4
the shredder
paper maximumly,

service.
Call:1-844-728-6917
Eamil:[email protected]
To ensure proper operaon and funcon, periodic oiling of the cung system is required.
Failure to oil your cung system could result in reduced sheet capacity performance, excess
noise, paper jams and possibly machine failure. Oil your cuers every 5th or 6th me you
empty the basket, if excess squeaking and rubbing noise is coming from the machine or if the
shredders sheet capacity has diminished. Squeeze the lubricant across the full width of the
cuers. Push the switch to ‘AUTO’ posion, and then insert paper to acvate the cung
system forward for 3 seconds. Then push the switch to ‘REV’ posion to make shredder reverse
for 3 seconds. Alternate between AUTO and REV at least three mes or unl all paper clears
the cuers.
Cuer Oiling Instrucons
Never use flammable synthec oil, petroleum based or aerosol lubricants to oil your cung
system. Use only a vegetable oil based lubricant in a non-aerosol container with
Noce

Cross cut
1/5" x 1 14/25" (5x40mm)
70dB
1.8m/min(10 Sheets)
5.5 gallons (21L)
10 Sheets
8.7 inch
of first purchase
5